1. 3fe574b.exe Driver
2. NWDOSODI.TXT File Contents

NWDOSODI.TXT Driver File Contents (3fe574b.exe)

3Com Corporation
3CCFE574BT 10/100 LAN PC Card
3CXFE574BT 10/100 LAN PC Card
Network Drivers Installation Notes

WINDOWS 3.1X AND NOVELL NETWARE

This document describes how to configure 
the LAN card for Windows V3.1x 
(Not Windows for Workgroups) and Novell NetWare. 

NOTE: The following instructions assume you have not
      installed any other network adapter in the PC. If
      networking has already been installed, some of the
      instructions will not apply or appear accurate.
      Consult with your MIS department for further
      instructions.

Before installing the network driver, 
you should know the transport used in the 
Novell Network (typically IPX/SPX) and 
have access to the following software components:

- Novell NetWare VLM Client disks for DOS and Windows
- The EtherDisk diskette that came with your LAN card.

Installation Instructions

 1. Boot the PC in DOS. If the PC starts up in Windows,
    exit Windows to return to the DOS prompt. 

 2. Place the Novell VLM client disk #1 in the floppy
    drive. Type:

    a:\install <Enter>.

    This opens the NetWare client installation screen.

 3. Use the down arrow key to move from line to line.       
    Ensure that the information is correct. 
    When you are asked to select the driver for your
    network card, press <Enter> to see the list of     
    supported adapters. 
    At the bottom of the list, find and select 
    Other Drivers.

 4.  When prompted for a driver disk, put      
     the Installation Disk in your floppy 
     drive, enter a:\nwclient and press <Enter>. 

     FE574B-3Com 10/100 LAN PCCard-Fast Ethernet 
     should appear as the first item on the list.  
     Click to select it and press <ENTER>.

 5. Specify the frame type. 
    Press <ENTER> and choose
    the appropriate type from the list. 
    Press <Enter> to select your choice. 
    (You will not need to select an I/O Base.
    Use the default.)

 6. Press F10 to return to the main 
    installation screen.
    Position the cursor on line 6 and 
    press <Enter>. 
    The installer prompts for several diskettes     
    and notifies you when the installation 
    is complete.

 7. Press <Enter> to exit the installation 
    program and return to DOS.

 8. Reboot the PC by pressing <CTRL><ALT><DEL>. 
    When you go into Windows You will be able 
    to LOGIN to the Novell Servers.

%VER 1.000.002