1. en2220.zip Driver
2. NDIS.TXT File Contents

NDIS.TXT Driver File Contents (en2220.zip)

.TOPIC:
Contents

		 ACCTON TECHNOLOGY CORPORATION                  
		     EN2220 Fast EtherCard-32 
	      10/100 Fast Ethernet CardBus PC Card 

		   NDIS 2 Driver Installation 

EN2220 has NDIS 2 driver support for the following environments:

   - Microsoft LAN Manager 
   - IBM LAN Support Program

Before you execute the NDIS 2 driver, you have to execute the EN2220
card enabling program CBOPEN.EXE first.

The EN2220 Microsoft LAN Manager NDIS driver and installation files are
stored under the \MSLANMAN.DOS directory on the driver disk:

   \MSLANMAN.DOS\DRIVERS\ACCTON\ETHCB

       EN2220.DOS          The DOS NDIS MAC driver
       PROTOCOL.INI        A sample PROTOCOL.INI file

   \MSLANMAN.DOS\DRIVERS\NIF

       ETHCB.NIF           Installation Network Information File

The EN2220 NDIS driver support for other environments are stored under the
\NDIS directory.  The organization of this directory is as follows:

   \NDIS

       NDIS.TXT            This readme file

       LANMAN.TXT          The Installation guide for
			   LAN Manager

       LANSVR.TXT          The Installation guide for LAN Server


   \NDIS\DOS

       ACC2220.NIF         Network Information File for IBM LAN Support 
			   Program
       EN2220.DOS          The DOS NDIS MAC driver

       PROTOCOL.INI        A sample PROTOCOL.INI file

Sample PROTOCOL.INI Files and Parameters
----------------------------------------

[ETHCB_NIF]

  DRIVERNAME = EN2220$
; Slot = 1            ;; {1-16}
; SIA_Mode = AUTODETECT
; {SIA_Mode = TP, TP_FULL_DUPLEX, AUTODETECT}
; DATA_RATE = MB10   ;; {MB10, MB100}

There are several parameters included in the ETHCB_NIF section of the
PROTOCOL.INI file. However, the only parameter that is necessary to specify
is the "DRIVERNAME."

If you change other parameter settings, such as the SIA_MODE, make sure
that it matches the hardware setting.  Otherwise, the card may fail.

If you don't specify these settings, the NDIS/2 driver will try to detect them
automatically.

SLOT        Specifies which CardBus PC Card is activated by the driver.  If you
	    have only one EN2220 card in your machine, this parameter
	    is unnecessary.  For two or more EN2220 cards, this
	    parameter is required and cannot be omitted from PROTOCOL.INI.
	    For the first EN2220, set Slot=1, and for the second one, set i
	    Slot=2, etc.

SIA_MODE    Specifies the medium type used by the card.  Acceptable values 
	    for this parameter are AUTODETECT, TP, and TP_FULL_DUPLEX. If you 
	    didn't specify this parameter, it would be set to AUTODETECT.

DATA_RATE   Specifies the line speed.  Default value is MB100.

	    MB100: 100Mbps, MB10: 10Mbps

TX_THRESHOLD
	    Specifies the FIFO threshold level during packet transmission.
	    Acceptable values are:

	    Keywords    Level  (Bytes) 
	    ========    ==================     
	      LW128        128           
	      LW256        256          
	      LW512        512         
	     LW1024        1024        
	       FP          full packet