PRODINFO.TXT Driver File Contents (4001850C.exe)

SPECIFICATIONS

AccelePort USB 2 Module Specifications

Power Requirements
The USB 2 module is powered from the USB bus that connects it to the
the host computer. Each module draws:
    10 milliamps maximum (suspend mode)
    100 milliamps maximum (power-up mode)
    200 milliamps maximum (active mode)

Environmental
    Ambient temperature  10 to 40 degrees C
    Relative humidity    5% to 90%
    Altitude             0 to 12,000 feet

Serial Interface Surge Protection
    15 kilovolts per IEC 1000-4-2, Level 4

Dimensions
    Length               4 inches
    Width                2.4 inches
    Height               1 inch
    Weight               0.4 pounds
    USB Cable length     6 feet


AccelePort USB 4 and USB 4 EIA422 Module Specifications

Power Requirements
The USB 4 module is powered from the USB bus that connects it to the
the host computer. Each module draws:
    10 milliamps maximum (suspend mode)
    100 milliamps maximum (power-up mode)
    200 milliamps maximum (active mode)

Environmental
    Ambient temperature  10 to 40 degrees C
    Relative humidity    5% to 90%
    Altitude             0 to 12,000 feet

Serial Interface Surge Protection
    15 kilovolts per IEC 1000-4-2, Level 4

Dimensions
    Length               6.3 inches
    Width                3.75 inches
    Height               1.2 inches
    Weight               0.5 pounds
    USB Cable length     6 feet


AccelePort USB 8 Module Specifications

Power Requirements
The USB 8 module is powered by an auxiliary power unit provided with
the module. It draws no power from the USB bus. Each module draws:
    500 milliamps maximum

Up to 500 milliamps of additional current will be drawn for each
downstream USB port which is used by a bus-powered USB device.

Environmental
    Ambient temperature  10 to 40 degrees C
    Relative humidity    5% to 90%
    Altitude             0 to 12,000 feet

Serial Interface Surge Protection
    15 kilovolts per IEC 1000-4-2, Level 4

Dimensions
    Length               8.1 inches
    Width                4.5 inches
    Height               1.5 inches
    Weight               0.9 pounds
    Power unit weight    0.3 pounds
    USB Cable length     6 feet



REGULATORY NOTICES

AccelePort USB 2
AccelePort USB 4
AccelePort USB 4 EIA422
AccelePort USB 8

The above listed products comply with the following standards, as
detailed below:

    FCC Part 15 Class B
    ICES 003 Class B
    EN55022 Class B
    EN50081-1
    EN50082-2

FCC (Federal Communications Commission) Statements

FCC Part 15 Class B Radio Frequency Interference (RFI) (FCC 15.105)
This equipment has been tested and found to comply with the limits
for Class B digital devices pursuant to Part 15, Subpart B of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
environment. This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try and correct the interference by one or more of the
following measures:

    Reorient or relocate the receiving antenna.
    Increase the separation between the equipment and the receiver.
    Connect the equipment into an outlet on a circuit different from
      that to which the receiver is connected.
    Consult the dealer or an experienced radio/TV technician
      for help.

Labeling Requirements (FCC 15.19)
This device complies with Part 15 of FCC rules. Operation is subject
to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.

Modifications (FCC 15.21)
Changes or modifications to this equipment not expressly approved by
Digi may void the user=92s authority to operate this equipment.

Cables (FCC 15.27)
Shielded cables must be used to remain within the Class B
limitations.

Declaration of Conformity
In accordance with FCC Dockets 96-208 and 95-19 Digi International
declares that the product:

Manufacturer=92s Name: Digi International Inc.

Corporate Headquarters: 11001 Bren Road East, Minnetonka MN 55343

Manufacturing Headquarters: 10000 West 76th Street, Eden Prairie
    MN 55344

Product Name              Model #
AccelePort USB 2          70001417
AccelePort USB 4          70001419
AccelePort USB 4 EIA422   70001421
AccelePort USB 8          70001418

The products listed have been tested at an External Test Laboratory
certified per FCC rules and have been found to meet the FCC,
Part 15, Class B, Emission Limits. Documentation is on file and
available from the Digi International Homologation Department.


ICES (Industry Canada Compliance Statements) 003 Class B
This Class B digital apparatus meets the requirements of the
Canadian Interference-Causing Equipment Regulations.

Cet appareil num=E9rique de la Classe B respecte toutes les
exigences du R=E8glement sur le mat=E9riel brouilleur du Canada.
Download Driver Pack

How To Update Drivers Manually

After your driver has been downloaded, follow these simple steps to install it.

  • Expand the archive file (if the download file is in zip or rar format).

  • If the expanded file has an .exe extension, double click it and follow the installation instructions.

  • Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.

  • Find the device and model you want to update in the device list.

  • Double-click on it to open the Properties dialog box.

  • From the Properties dialog box, select the Driver tab.

  • Click the Update Driver button, then follow the instructions.

Very important: You must reboot your system to ensure that any driver updates have taken effect.

For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.

server: ftp, load: 2.08