1. fem556d2.exe Driver
2. NWDOSODI.TXT File Contents

NWDOSODI.TXT Driver File Contents (fem556d2.exe)

File: nwdosodi.txt
3Com Corporation

3Com Megahertz 10/100 LAN + 56K Modem PC Card
(3CCFEM556 PC Card family)

============================================================
WINDOWS 3.1X AND NOVELL NETWARE
-------------------------------

This file describes how to configure the LAN+Modem
card for use with Windows version 3.1x and Novell
NetWare.

This file includes the following topics:
 - General Information
 - Before Installing the Network Driver
 - Installation Instructions

============================================================
General Information
-------------------

The following instructions assume you have not
installed any other network adapter in the PC. If
networking has already been installed, some of the
instructions will not apply or appear accurate.
Consult with your MIS department for further
instructions.

============================================================
Before Installing the Network Driver
------------------------------------

Before installing the network driver, you should know the
transport used in the Novell Network (typically IPX/SPX)
and have access to the following software components:

- Novell NetWare VLM Client disks for DOS and Windows
- The LAN+Modem card Installation Disk 2.

============================================================
Installation Instructions
-------------------------

1. Boot the PC in DOS. If the PC starts up in Windows, exit
   Windows to return to the DOS prompt. 

2. Place the Novell VLM client disk #1 in the floppy drive.
   Type:

   a:\install <Enter>.

   This opens the NetWare client installation screen.

3. Use the down arrow key to move from line to line. Ensure
   that the information is correct. When you are asked to
   select the driver for your network card, press <Enter>
   to see the list of supported adapters. At the bottom of
   the list, find and select Other Drivers.

4. When prompted for a driver disk, put Installation
   Disk 2 in your floppy drive and press <Enter>. The
   LAN+Modem card should appear as the first item on the
   list. Select it and press <Enter>.

5. Specify the frame type by pressing <Enter> and choosing
   the appropriate type from the list. Press <Enter> to
   select your choice. (You will not need to select an I/O
   Base. Use the default.)

6. Press F10 to return to the main installation screen.
   Position the cursor on line 6 and press <Enter>. The
   installer prompts for several diskettes and notifies you
   when the installation is complete.

7. Press <Enter> to exit the installation program and
   return to DOS.

8. Reboot the PC by hitting <CTRL><ALT><DEL>. When you go
   into Windows You will be able to LOGIN to the Novell
   Servers.

The configuration manager (FMENABLE.EXE) must be added to
the AUTOEXEC.BAT file or CONFIG.SYS file. Add the line:

        FMENABLE

Specify a directory path if required. Typically, the path
name will be C:\MHZ or C:\NWCLIENT.

(%ver nwdosodi.txt v1.0)