This is RL2000 PCI SCO OpenServer5 driver (LLI specification) update file.
*********************************************************
*** NOTE:- LLI specification cannot remove the driver with netconfig
alone in SCO 5.
To remove the driver completely, you MUST run netconfig
and custom to remove the driver.
e.g. Suppose run netconfig for 2 boards and later decide to remove
away one board.
You will first have to remove both boards with netconfig and
custom. Then relink and reboot.
Run custom again to install the driver. Then run netconfig to
install and configure for one board, relink and reboot.
**********************************************************
Prepare driver disk
====================
1) Run RPCI10B.EXE to a blank diskette to extract it.
2) Copy RPCI10B.DD to SCO UNIX hard disk
e.g.,
doscp /dev/fd0:rpci10b.dd .
3) Check the checksum with the command,
sum rpci10b.dd
The value should be 21982
4) Format a new 1.44MB disk
5) Run dd to extract to diskstte.
e.g.,
dd if=rpci10b.dd of=/dev/fd0
6) Label disk as, RL2000 PCI SCO UNIX driver
version 1.0b
To install the driver, run custom and netconfig
Refer to SCO UNIX 5 for more detailed installation
procedures.
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.