1. IEE_10.ZIP Driver
2. NWODIOS2.TXT File Contents

NWODIOS2.TXT Driver File Contents (IEE_10.ZIP)

   Workstation for OS/2 Requester Client
                                                                    v3.03


NetWare OS/2* ODI Client Driver Installation Notes for Intel's
EtherExpress(TM) PRO/10 ISA LAN Adapter
==============================================================

Location of Driver:     \OS2\EPROODI.SYS


Sample Configuration Files
--------------------------

CONFIG.SYS (will contain)
   
   DEVICE=C:\NETWARE\EPROODI.SYS

NET.CFG
   
   LINK DRIVER EPROODI
      PORT 300
      FRAME ETHERNET_802.3
      FRAME ETHERNET_802.2


General Installation
--------------------

NOTE:    If you are running IBM OS/2* 2.0 or OS/2 2.1, you will need to
         have the OS/2 Requester version 2.01 or later (available from
         Novell).

If you have a Plug and Play BIOS, make sure you DISABLE Plug and Play on
your adapter using SoftSet2 (Change Adapter Configuration, Advanced
Options menu). OS/2 doesn't support Plug and Play. It doesn't support a
Configuration Manager. As a result, OS/2 may not be able to find your
adapter if Plug and Play is enabled.

1  Run Novell's INSTALL utility on the OS/2 Requester disk and follow
   Novell's instructions. When asked to enter the name of the network
   interface driver, enter EPROODI.SYS.

2  Choose the session support you need. This is based on your
   configuration. See the NetWare* Requester manual if you need help.

3  Save the configuration.

4  When asked to enter the path and filename for the driver, insert the
   driver disk in drive A and enter  A:\OS2\EPROODI.SYS.

5  When the installation section is complete, select "Configuration" from
   INSTALL's main menu, then select "This Workstation". This will allow
   you to modify the NET.CFG file.

NOTE:    The default frame type for EPROODI.SYS is 802.2. If you are
         using the 802.3 frame type, you have to include a frame
         statement in the NET.CFG file. See the NET.CFG example above.


Hints and Tips
--------------

1  Verify Driver Loaded Properly

   In the Config.sys file, put a "fake" device=xxx statement following
   the EPROODI.SYS line. The screen will stop and you can check for error
   messages.

2  Error message "not getting a connection ID"

   This OS/2 error usually results from a frame type mismatch. Ensure the
   NetWare* server (type CONFIG at console) and this workstation (review
   NET.CFG file) are loading the same frame types.

3  NET.CFG Options

   All NET.CFG options (except LINK DRIVER EPROODI) are optional for
   single adapter installations.

   PORT - This is the base I/O address of the adapter. If the port option
   is not present, it will try to load at I/O 300. If the board is not at
   300, it will return with an error message stating board not found.

   INT - <optional> The system IRQ for the adapter to use. This option is
   only used as a reminder which IRQ the board is set for. It does not
   cause the driver to override the EEPROM contents.

   NODE ADDRESS - This parameter allows the driver to override the
   Ethernet address in the EEprom. This is Novell's node address override
   feature. To comply with Novell's multicast specification, the second
   digit of the overriding address should be a 2, 6, A or E.

   Syntax:
      NODE ADDRESS 00AA00123456



* Third-party trademarks are the property of their respective owners.