Additional Information
Sound Galaxy Waverider Pro 32A - 3D V2.00
This file contains additional information and changes about the
various software that was not available at printing time.
CD-ROM Drive Support
====================
The bundled CD-ROM device driver supports only on the following drives:
Driver CD-ROM Model
------ ------------
SGIDECD.SYS - Aztech CDA268-03I / CDA268-03ISE / CDA468-01I /CDA668-01I
Using Digital (.WAV) Audio with DOS 6.x's DoubleSpace*
======================================================
The DoubleSpace utility included with DOS 6.x can cause problems
if you attempt to play or record "high data rate" (i.e.: stereo/
44.1kHz/16-bit) digital audio to or from a compressed disk.
Therefore, if you anticipate that you will be playing or recording
a lot of stereo/44.1kHz/16-bit digital audio, you should set up a
non-compressed drive partition and configure the audio application
to use this drive as their Work and Temp directories.
For information on setting up a non-compressed partition for your
hard drive, refer to your DOS 6.x Users Guide.
The same procedure should be followed if you are using Stacker, a
third-party disk compression utility.
Notes About Using EMM386.EXE
============================
When running applications with EMM386.EXE installed, the following
error message may appear:
"EMM386 DMA buffer is too small"
You can overcome this problem in two ways:
- remove the EMM386.EXE entry from the CONFIG.SYS file
OR
- add the following parameter to the EMM386.EXE entry in the
CONFIG.SYS file:
D=64
where D specifies how many kilobytes of memory should be
reserved for buffered Direct Memory Access (DMA).
An example of this may be:
C:\WINDOWS\EMM386.EXE D=64
***********************************************************
* In case you encounter any problem with our products, *
* please quote the following model(s) when calling our *
* Technical Support : *
* HornBill Sound Card *
***********************************************************
------- The End ---------
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.