1. dfo64.exe Driver
2. readme.txt File Contents

readme.txt Driver File Contents (dfo64.exe)

============================================
ANA-620XX AND ANA-690XX DOS DIAGNOSTICS
============================================

The diagnostics are intended to operate on MS-DOS
version 6.22.  You may operate the diagnostics
under Win95 and Win98 by setting up using the
instructions listed in the section below labeled 
"1. RUNNING DIAGNOSTICS FROM A HARD DRIVE", then
choosing the "Restart the computer in MS-DOS mode"
selection in the system shutdown menu.

The diagnostics DO NOT operate under WinNT.


This readme file contains the following sections:

1. Running diagnostics from a hard drive.

2. Running diagnostics from a floppy drive.

3. Miscellaneous runtime information.


============================================
1. RUNNING DIAGNOSTICS FROM A HARD DRIVE
============================================

Operate the diagnostics from your hard drive
as follows:

1) Make sure himem.sys and emm386.exe are
	currently in your config.sys file,
	and that files=30 is there.

	If they are not, add the following
	lines to the top of the config.sys
	file:

	device=c:\dos\himem.sys
	device=c:\dos\emm386.exe /noems
	files=30

	NOTE: Insert your path to the DOS
	programs if it is not c:\dos.

2) Create a directory for the diagnostics
	on your hard drive. 

3) Copy all the files in this directory to the
	new diagnostics directory of hard drive.

4) Invoke the diagnostics by typing go_diags in
	the new diagnostics directory.

NOTE: 
	Certain PC BIOSes do not provide all the XMS services
	required.  If you encounter errors running diagnostics, 
	running the smartdrv.exe program will replace the BIOS 
	XMS routines with the correct XMS services.    

5) If you still encounter errors operating diagnostics,
	please try the method below, Running
	diagnostics from a floppy drive.


=============================================
2. RUNNING DIAGNOSTICS FROM A FLOPPY DRIVE
=============================================

Prepare a DOS diagnostics boot diskette 
as follows:

1) Create a bootable DOS diskette.

2) Copy the DOS files himem.sys, emm386.exe,
	and smartdrv.exe to the diskette.

3) Copy all the files in this directory to the
	root directory of the DOS boot diskette.

4) Boot the computer from the floppy diskette.

5) Invoke the diagnostics by typing go_diags.



=============================================
3. MISCELLANEOUS RUNTIME INFORMATION
=============================================

1) Use the "selftest" command to test the 
	functionality of your adapter.

2) Use the "?" key to list available diagnostics
	commands.

3) You may experience error messages and may need
	to reboot your system if you exit diagnostics
	by using <Ctrl> C.  Use the exit command
	to exit diagnostics.

4) The "echoer 0" command will echo packets forever.
	You will need to reboot your system to exit 
	from the "echoer 0" command.

5) It is recommended that the echoer and sender tests be
	performed on a private network between systems that 
	are connected with a hub, not a switch.

6) For multiport adapters, the top port is port 1, and
	the next lowest port is port 2 etc.  Some rare system BIOSes
	allocate port 1 as the bottom port.

7) The diagnostics are to test one board per system.  It is
	recommended that only one board be installed in the system
	when diagnostics are performed.

8) Check the Adaptec website for the latest 
	diagnostics updates.  http://www.adaptec.com