1. pcmcia.zip Driver
2. MSLANMAN.TXT File Contents

MSLANMAN.TXT Driver File Contents (pcmcia.zip)

LAN Manager Workstation

Introduction:
-------------
This document describes the procedure to setup LAN  Manager 2.1
Workstation/Server driver for PCMCIA/CT II Ethernet adapter.

Location of Driver: \MSLANMAN.OS2\DRIVERS\ETHERNET\PCM200\PCM200.OS2

Setup Procedures:
-----------------
   Before you start with the installation process, make sure that
   the Card Manager software has been successfully installed. For
   information on installing the Card Manager software, please refer
   to the appropriate readme file, your Ethernet Adapter manual, or
   your computer manufacturer.

   1. Run the appropriate Microsoft Lan Manager SETUP for computer you
      are setting up.(DOS, OS/2 or OS/2 Server). Select "Configuration"
      item ,(the PCMCIA/CT II driver isn't included on the Lan Manager
      disk) and insert the PCMCIA/CT II driver disk, select the PCMCIA
      driver and follow the directions.

   2. When completed, reboot your computer .

Before installing the PCMCIA/CT II Ethernet LAN into workstation, you
have to append the following lines into config.sys and autoexec.bat
file or it would look like the following.

   CONFIG.SYS (for OS/2 will contain):

       DEVICE=C:\LANMAN.OS2\DRIVERS\PROTMAN\PROTMAN.OS2 /I:C:\LANMAN.OS2
       DEVICE=C:\LANMAN.OS2\DRIVERS\ETHERNET\ENET16A\ENET16A.OS2

     < Sample AUTOEXEC.BAT file >

	   @ECHO OFF
	   PROMPT $p$g
	   PATH C:\DOS;C:\LANMAN.OS2;

     <Sample PROTOCOL.INI file >

	   [PROTMAN]
	   DRIVERNAME = PROTMAN$
	   DYNAMIC = YES
	   PRIORITY = NETBEUI

	   [NETBEUI_XIF]
	   Drivername = netbeui$
	   SESSIONS = 6
	   NCBS = 12
	   BINDINGS = "PCM200_NIF"
	   LANABASE = 0

	   [PCM200_NIF]
	   DriverName = PCM200$
	   IOBASE = 0x300
	   INTERRUPT = 5