1. ricohUSB101.EXE Driver
2. README(U.TXT File Contents

README(U.TXT Driver File Contents (ricohUSB101.EXE)

*** USB Driver Version 1.0.1 Readme Text ***

[USB Driver System Requirements]
Platform: Windows 98 or 98 SE (Second Edition) preinstalled with operating factory USB port
Note: Driver not supported by Windows 95, systems upgraded to Windows 98
may not properly support this driver. This driver will not operate a USB
port. USB ports emulating from a PCI port may not function properly.

The first time you connect your camera to a USB equipped computer, you must
install the camera's USB drivers as described below:

[Driver setup procedure]
(1) After Windows 98 has booted, insert the Software CD included in your kit.
(2) Connect the camera to the PC using the supplied USB cable included in
your kit.
(3) When the camera is detected, the Windows 98 add hardware wizard will
launch.
(4) Select the CD-ROM drive to install the RDC-5000 drivers.
Important Note:
The camera's flash and autofocus LEDs will light while the USB driver is
installing. Never turn off the camera or disconnect the cable during this
period.
Notes:
The install wizard will launch twice. Allow the wizard to finish without
interruption. Use of the camera's AC adapter is recommended during file
transfer. Data may be corrupted by a sudden loss of power. Only use the
Ricoh USB cable included in your kit.

[File transfer procedures]
(1) After Windows 98 has booted , connect the camera to the PC using the
supplied USB cable.
(2) Turn on the camera and set the mode dial to [PC].
When Windows detects the camera, two drives (internal memory and SmartMedia
if you have one in the camera memory card) will appear in "my computer".
You can then copy images from the memory sources in the camera to your
computer's disk drives.
(3) To disconnect the camera, ensure the flash and autofocus LEDs are not
blinking and turn off the camera. Disconnect the USB cable.

Important Note:
The camera's flash and autofocus LEDs will blink while connected. Never
turn off the camera or disconnect cables during this period.  Damage to
your computer may result. Do not attempt to compress or format the memory
in the camera with ant disk tools.
The camera may not work correctly if it is connected to a PC in combination
with any other USB device.

Note:
If the process of copying files from a PC to the camera is interrupted, an
incomplete file may be left in the camera's memory. To correct this
problem, turn on the camera's power again and run a scan disk procedure
(standard) from the PC.

[End User License Agreement]
===========================
The following is a legal software license agreement between you, 
the software end user, and Ricoh Company Ltd. Carefully read 
this license agreement before using the product. 
Using the product indicates that you have read this license agreement
and agree to its terms.

Grant of License. 
  This license permits you to use one copy of the software included
  in this package on any single computer. 
  For each software licensee, the program can be "in use" on only 
  one computer at any given time. The software is "in use" 
  when it is either loaded into RAM or installed into the hard disk 
  or other permanent memory. A special license permit from Ricoh 
  is required if the program is going to be installed on a network 
  server for the sole purpose of distribution to other computers.

Copyright. 
  The software contained in this package is owned and published
  by Ricoh, and is protected by United States copyright laws, 
  international treaty provisions, and all other applicable national laws. 
  The software must be treated like all other copyrighted materials 
  (e.g. books and musical recordings). This license does not allow the 
  software to be rented or leased, and the written materials accompanying 
  the software (if any) may not be copied.

Limited Warranty. 
  Ricoh, warrant that the software contained herein will perform substantially
  in accordance with the accompanying documentation.

No Other Warranties. 
  Ricoh disclaim all other warranties, either express or implied, 
  including but not limited to implied warranties of merchantability and 
  fitness for a particular purpose, with respect to the Software, the 
  accompanying written materials, and any accompanying hardware (if any).

No Liability for Consequential Damages.  
  In no event shall Ricoh or its suppliers be liable for any damages 
  whatsoever (including but not limited to damages for loss of business profits, 
  business interruption, loss of business information, or any other pecuniary loss)
  which results from an inability to use this software, even if Ricoh have been 
  advised of the possibility of such damages.  Because some states/jurisdictions 
  do not allow the exclusion or limitation of consequential or incidental damages, 
  the above limitations may not apply to you.

U.S. Government Restricted Rights. 
  The Software and documentation are provided with Restricted Rights.  
  Use, duplication, or disclosure by the U.S. Government is subject to restrictions
  as set forth in subparagraph c(1)(ii) of the Rights in Technical Data and Computer
  Software clause at DFARS 252.227-7013 or subparagraphs c(1),(2), and (3) of 
  the Commercial Computer Software - Restricted Rights at 48 CFR 52.227-19, 
  as applicable, and any amendments thereto.  
  The manufacturers are Ricoh Company Ltd., 2-1-1, Ohmori-Kita, 2-Chome, 
  Ohta-ku, Tokyo, 143-0016 Japan.

If this product was purchased in the United States, this Agreement is governed by
the laws of the state of California; otherwise, local laws may apply. 

 Copyright (c) 1999, Ricoh Co., Ltd.



Microsoft and MS Windows are registered trademarks of Microsoft Corporation
in the U.S. and other countries. Macintosh is a registered trademark of
Apple Computer, Inc. in the U.S. and other countries. Other product names
and brand names are either trademarks or registered trademarks of their
respective owners.