1. ak47vlb_all.zip Driver
2. readme.txt File Contents

readme.txt Driver File Contents (ak47vlb_all.zip)

              The AK47VLB SCSI1 and SCSI2 Controller.
              ---------------------------------------

Specifications:
---------------
Internal Connector: IDC 50-pin
External Connector: SCSI2 DB25
SCSI Chip: Fujitsu MB86601A
Protocols Supported: SCSI1, and SCSI2
                     Disconnect/Reselect
                     Supports SCSI pass-through functionality
                     BUS device reset
                     Advanced SCSI Programming Interface (ASPI)
                     Single-threaded I/O

Maximum Burst: 10MB/sec
Bios Version 1.21

The AK47 controller card is compatible with the following
operating systems:
	MSDos
	Windows 31
	Windows 95a
	Windows NT 3.51 and 4.0
	OS2 Warp 3 and Warp 4
	Netware 3x and 4x
	
Termination:
------------
Termination on the card is controlled by three 10-pin terminator resisters
located near the internal connector. To disable termination on the card,
all resisters need to be removed. Keep these resisters in case termination
needs to be re-enabled at a future date. To enable termination, replace the 
resisters. Note pin one orientation on the resisters when installing.

Driver Installation:
--------------------

Drivers and instuctions are available on this disk in the following 
directories:

	MSDos/Windows31   a:\dos
	Windows 95a       a:\win95
        Windows NT 3x 4x  a:\winnt
	Netware 3x        a:\netware\3x
	Netware 4x        a:\netware\4x
	OS2 Warp 3x 4x    a:\os2
	Bios Utility      a:\flash-bios

Please use the README.TXT in each directory for additional information.

------------------------
Corporate Systems Center
1294 Hammerwood Ave
Sunnyvale CA 94089
408-734-3475

How To Update Drivers Manually

After your driver has been downloaded, follow these simple steps to install it.

• Expand the archive file (if the download file is in zip or rar format).

• If the expanded file has an .exe extension, double click it and follow the installation instructions.

• Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.

• Find the device and model you want to update in the device list.

• Double-click on it to open the Properties dialog box.

• From the Properties dialog box, select the Driver tab.

• Click the Update Driver button, then follow the instructions.

Very important: You must reboot your system to ensure that any driver updates have taken effect.

For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.