1. MOBILV90.EXE Driver
2. Manual Flash.TXT File Contents

Manual Flash.TXT Driver File Contents (MOBILV90.EXE)

          Manual install of the V.90 Code for the MobileSurfr



After running the V.90 Flash Code for the 56k  MobileSurfr  and the program doesn’t find the modem 
do the following.



A. Go to Start, Programs ,  Accessories, Hyperterminal.  Now that you are in HyperTerminal click on Hypertrm or Hypertrm.exe.   Next it 
will say Enter a name and choose an icon for connection, here type "test" in the Name block and then 
click on OK.  Another screen will pop up and here all you want to type in the telephone number block 
"12345" and make sure that in the Connect Using field that the MobileSurfr is listed.  Now click on 
OK.  In the next screen click on Cancel and you should be in a white screen with a black flashing 
cursor.

B. Type "AT" and hit the Enter key and it should respond with an "OK" message back.  IF it doesn’t then 
the Modem is not installed right and will need to be reinstalled at this point you will need to follow the 
reinstall procedure.    Next type "ATI3" and this should give you the rev of the 56K MobileSurfr.  
Now you will type the following  command "AT**" and hit the enter type .  The response message 
from the modem will be that it is looking for the flash code.

C. Now click on Transfer and select Send Text File.  In the LOOK in Box  click on the down arrow and 
select  the C: .  Now choose the folder where you extracted this file to and double click on it .  Next double click on the 
Mobile  folder .  In the Files of Type box select All Files(*.*) and you will see the Motflash.S37 file 
and Highlight this file and click on Open.   This will send the first part of the flasher code to the 
modem.  After this code is download the modem will ask for the next part of the code, repeat the 
transfer process again but this time select the file Unco56c.Hex .  The modem will respond with the 
following message "Download is complete".  

D. Now close and save this terminal session.  Reopen the Test Icon and the select cancel .  Type AT^I and 
the modem will respond will the flash code.  Close all program and reinstall the MobileSurfr 56K with 
the new inf file that will enable the cellular protocol.