1. ep401v2_6.zip Driver
2. README File Contents

README Driver File Contents (ep401v2_6.zip)

****************************************************************************
*                                                                          *
*                         PCMCIA Ethernet Adapter                          *
*                                                                          *
*                 LANtastic AI-LANBIOS Compatible Driver                   *
*                                                                          *
*                               Ver. 4.04                                  *
*                                                                          *
*                              README file                                 *
*                                                                          *
****************************************************************************

1. Introduction:

   This Ethernet LANtastic AI-LANBIOS Compatible Driver supports 802.3 and
   XEROX frame type.  Ensure that you have an adapter-independent version
   of the LANtastic product and the LANtastic NOS/AI, since AE-2 LANtastic
   v3.02 or later can no longer work with non-Artisoft hardware.


2. Contents of the Subdirectory:

      E2K.EXE         The LANtastic AI-LANBIOS compatible driver that
                      supports AILANBIOS v4.04 specification.  It works
                      with LANtastic v5.00 and LANtastic v6.00.


3. Installation

   1) Install the PCMCIA Ethernet Adapter on your system, following the
      procedure described in your PCMCIA Ethernet adapter user's manual.

   2) Install the LANtastic product following the instructions in your
      LANtastic Network Operating System User Manual.

   3) When you are asked to select the type of your LAN adapter, choose
      "NEX016 Novell NE2000 16-bit ISA Bus or Compatible".

   4) When the installation is completed, edit STARTNET.BAT to replace the
      line "NEX000..." with "E2K IRQ=3 IOBASE=300 VERBOSE", as the
      following example shown:

                .
                .
                ( SHARE /L:200 )

                E2K IRQ=3 IOBASE=300 VERBOSE
                AILANBIOS
                REDIR PCNAME LOGINS=3

                ( SERVER )
                NET LOGIN \\SERVER USER
                .
                .

       Note: You should change the IRQ and I/O base address according to
             the hardware settings.

    5) Copy E2K.EXE from the Ethernet Driver Disk to \LANTASTI of your
       hard disk.

    6) Run STARTNET.BAT to start LANtastic NOS.


4. Unload

   To unload the driver, firstly remove AILANBIOS, then remove the driver,
   as shown below:
                 .
                 .
                 AILANBIOS REMOVE
                 E2K REMOVE