1. lan_dirv.zip Driver
2. PC-NFS.TXT File Contents

PC-NFS.TXT Driver File Contents (lan_dirv.zip)

FILE NAME: PC-NFS.TXT
=====================

******************************************************************************
*   Sun Microsystems PC-NFS (Version 3.5+)
******************************************************************************

1.  Install PC-NFS for Ethernet according to instructions in the PC-NFS 
    documentation.  Choose NDIS setup, and complete the setup.

2.  Rename the file PROTOCOL.NFS in the C:\LANMAN subdirectory to 
    PROTOCOL.INI.  Use an ASCII text editor to edit the PROTOCOL.INI file
    as follows:

    Replace the items

        [your-mac-module]
        drivername = YOURMAC$
        [NFS-NDIS]
        drivername = NFSLINK$
        bindings = your-mac-module

    with

        [GCS2000_NIF]
        drivername = NE2000$
        iobase=0x300
        interrupt=3

        [NFS-NDIS]
        drivername = NFSLINK$
        bindings = GCS2000_NIF

3.  Copy the file NE2NDIS.DOS from the \NDIS subdirectory on your Drivers 
    Diskette to the C:\LANMAN subdirectory.

4.  Use an ASCII text editor to insert the following lines in your 
    CONFIG.SYS file:

        DEVICE = C:\LANMAN\C1SC.EXE
        DEVICE = C:\LANMAN\NE2NDIS.DOS

    between

        DEVICE = C:\LANMAN\PROTMAN.SYS     and

        DEVICE = C:\LANMAN\NFS-NDIS.SYS


5.  Make sure the PROTOCOL.INI file created contains the same IOBASE, and
    INTERRUPT numbers as specified by C1SC.

6. Reboot the PC.

Note: If you are using an extended memory manager and the C1SC enabler, 
      you may need to explicitly exclude memory area D800-D8FF, or other 
      4 Kbyte memory space defined by the /MEM parameter.