1. AOpenNIC.zip Driver
2. NWODIDOS.TXT File Contents

NWODIDOS.TXT Driver File Contents (AOpenNIC.zip)

   Workstation for DOS ODI Client

   Introduction:
   -------------
   This document describes the procedure to setup the NetWare v3.X , v4.X
   5.0 workstation driver for AOpenLAN ALN325 PCI ethernet adapter.

   Location of Driver:     \nwclient\ALN325C.COM

   Sample Configuration Files:
   ---------------------------
     STARTNET.BAT:
         LSL
         ALN325C
         IPXODI
         NETX or VLM (VLM's for NetWare 4.x,5.0 )

     NET.CFG:
         LINK DRIVER ALN325C
           SPEED 100  --Specify adapter's speed.

           BUSNO NN   --where NN is the PCI bus identifier of the PCI bus
                        which connectsto the adapter.
           DEVICENO NN --where NN is the specific PCI BIOS device
                         identification number of the specified PCI adapter.
          [ or you can use "EtherID" to select a specific ALN325 adapter:
           EtherID NNNNNNNNNNNN --Where NNNNNNNNNNNN specify a ALN325
                                  adapter's node address.This is only
                                  required when more than one ALN325
                                  adapters exist on one system.
          ]


           FRAME Ethernet_802.2 --Specify frame type
           FRAME Ethernet_802.3
           FRAME Ethernet_SNAP
           FRAME Ethernet_II

         NetWare DOS Requester
           FIRST NETWORK DRIVE = F
           NETWARE PROTOCOL = NDS BIND
           PREFERRED SERVER = NW411


   Setup Procedures for NetWare 3.12 Client :
   -----------------------------------------------
      Before you start with the installation process, make sure that
      the  adapter is properly installed and configured. Make sure
      that your NetWare workstation is properly installed.

      1. Copy  ALN325C.COM from the ALN325  Driver Diskette subdirectory
         A:\NWCLIENT to your harddisk.

      2. Create a batch file, or add to your STARTNET.BAT file the commands
         listed above under STARTNET.BAT

      3. Edit the NET.CFG file that you copied over. Edit the file per your
         requirements (see examples above).  If there are two frame types
         listed, whichever frame type is listed first, that is the one that
         the  driver will load.  See above for examples.  The NET.CFG file
         should be in the same directory with the LSL.COM file.


   Setup Procedures for NetWare 4.X,5.0 Client with vlm:
   -----------------------------------------------
      The  installation utility  INSTALL.EXE  is  located on the root 
      directory of disk 1. Run INSTALL.EXE from the Workstation
      for DOS Disk.

      1. Choose to install Novell ODI client.
                                                             
      2. Enter the destination directory for the NetWare Client.
         (The default directory is C:\NWCLIENT).

      3. Automatically update the CONFIG.SYS and the AUTOEXEC.BAT files
         

   NOTE:
   -----
      1. Be sure LASTDRIVE=Z in your CONFIG.SYS file for the
         network mappings to work properly.

      2. When you have multiple ALN325 Adapters on your system:
         Use "BUSNO" and "DEVICENO" KEYWORD in NET.CFG to select which
         adapter to use with your netware client.(or you can use "EtherID")


                                                        -- end --