Accton Technology Corporation
EN1203 PCI adapter
=============================
Copyright (c) 1994, 1995 by Accton Technology Corporation.
All rights reserved.
How to Config Your PCI adapter.
-------------------------------
1. First , you must find the PCI configuration item in BIOS setup.
2. There are some key point you must take care of.
a). You should know what slot your adapter plug in. You can find the
slot number in your mother board. Or you can see your mother board
menu.
b). Enable this device.
c). Enable "master" this item.
The EN1203 PCI adapter MUST be installed in a bus master PCI slot
Refer to your system documentation to determine which slots support
bus mastering.
d). You can choise what interrupt line you used in some BIOS setup.
For our adapter , you must choise "INT A" in this item.
e). Choise what interrupt number you want. You can assign it in what
interrupt you choise or in the slot number you choise.
d). Choise the interrupt mode. In our adapter you may choise edge triggered
or level triggered, shared interrupts require level-triggering.
Multiple EN1203 PCI adapters can share the same PCI interrupt and
all must use INTA with level-triggered mode.
3. When you finish your configuration. You can run the diagnostic program in
the driver diskette. If any problem , contack your dealer or Accton tech.
corp..
Conflict with Microsoft EMM386
-------------------------------
problem:
EN1203 users may experience a hang and/or reset situation when using
any version of EMM386 prior to version 4.49. Whenever EN1203 drivers
execute a 32-bit I/O read the system may hang and/or reset.
fix:
Use version 4.49 or higher releases of the EMM386 memory manager(
available with MS-DOS version 6.22).
End-users with earlier version of the EMM386 memory manager should
contact their OEM or Microsoft for information on obtaining an
updated EMM386 device driver.
Support for 5 Volt PCI Slots
----------------------------
The EN1203 PCI adapter currently supports only 5 volt PCI slots.
It will not fit in a 3.3 volt slot.
A future release of the adapter will support both 3.3 and 5 volt
PCI slots.
note: 1. In some PCI-ISA computer which requires manual configuration.
when you setup interrupt you must move the jumper also, for
example, if you set INTA to interrupt 5 via a BIOS configuration
setting, you must also set the jumper on your motherboard to ISA
interrupt 5.
2. Usually , the PCI machine only support two Master Device.
And, the SCSI is master device too.
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.