1. 5625-unkg-v90b2w95.exe Driver
2. SVREADME.TXT File Contents

SVREADME.TXT Driver File Contents (5625-unkg-v90b2w95.exe)

Updating your Supervoice 2.2 Install Disks For Use with V.90 
Professional Message Modems Using Windows 95 or Windows 3.x:

Copy the Install.ini file located on your upgraded V.90 floppy disk 
onto your hard drive eg C:\TEMP.

Ensure that the floppy disk labelled 'Supervoice 2.2 Disk 1 
of 2' is not write protected, by pushing down the plastic 
tab in the top right corner of  disk, so that it blocks the 
small square hole.

Insert this disk into your floppy disk drive eg. A:\

From the DOS prompt: 

If you are not familiar returning to the DOS prompt from
within Windows use the following procedure.
   
          For Windows 3.x :
          1. From the PROGRAM MANAGER
          2. Select  the WINDOW menu
          3. Click on MAIN
          4. Click on MS-DOS PROMPT


          For Windows 95 :
          1. From Windows Desktop Task Bar
          2. Click on 'START'button
          3. Move up to 'PROGRAMS' menu
          4. Move cursor across to select 'MSDOS PROMPT'


From the MSDOS prompt,

Use the CD command to go to the directory where the Install.ini file is located on your hard drive. eg. CD\TEMP should take 
you to the directory  C:\TEMP, where C:\ is your local hard drive.

Then type ,
           copy install.ini A:\

This should copy the file INSTALL.INI from the TEMP directory on 
your hard drive in to the root directory of the floppy disk.
 
Remove the floppy disk, and switch the write protect tab 
back to its open position. Supervoice 2.2F/P can be installed 
for your use with your new V.90 version of the Professional 
Message Modem.