1. pe200c.exe Driver
2. README.TXT File Contents

README.TXT Driver File Contents (pe200c.exe)

             Local Area Network Software Driver Support
             for PMX PCMCIA ethernet adapter


    < I > To configure this adapter and install software, please type:

          INSTALL <Enter>

          and follow the on-screen instructions.


    For more information, see your Installation Manual.

    < II > Software Installation Advisory

          1. For those who installed EMM386.EXE in your CONFIG.SYS, please
             exclude memory address D000-D7FF from your system. Ethernet
             PCMCIA Card will use this space to read Ethernet ID and other
             information from the on-board flash ROM.

                Example : DEVICE=EMM386.EXE NOEMS X=D000-D7FF

           2. For those who installed Card and Socket Services device drivers
              in your CONFIG.SYS, please run NETOPEN.EXE after those device
              drivers since NETOPEN.EXE is a Card Services Client and should 
              only be  activated after the Card and Socket Services drivers 
              are activated.

                Example 1:(DataBook CardTalk)
                DEVICE=C:\CARDTALK\SS_2.SYS (Socket Service driver)
                DEVICE=C:\CARDTALK\CTALKCS.EXE (Card Service driver)
                DEVICE=C:\CARDTALK\CARDTALK.SYS (Super Client driver)
                DEVICE=C:\NETWORK\NETOPEN.EXE /PORT=300 /INT=5

                Example 2:(SystemSoft CardSoft)
                DEVICE=C:\CARDSOFT\SS365SL.EXE (Socket Service driver)
                DEVICE=C:\CARDSOFT\CS.EXE (Card Service driver)
                DEVICE=C:\CARDSOFT\CSALLOC.EXE C:\CARDSOFT\CSALLOC.INI
                DEVICE=C:\CARDSOFT\CARDID.EXE
                DEVICE=C:\NETWORK\NETOPEN.EXE /PORT=300 /INT=5

                Example 3:(Phoenix PCMPlus)
                DEVICE=C:\PCM3\CNFIGNAM.EXE /DEFAULT
                DEVICE=C:\PCM3\PCMSS.EXE (Socket Services driver)
                DEVICE=C:\PCM3\PCMCS.EXE (Card Service driver)
                DEVICE=C:\PCM3\PCMRMAN.EXE
                DEVICE=C:\PCM3\PCMSCD.EXE
                DEVICE=C:\NETWORK\NETOPEN.EXE /PORT=300 /INT=5


    < III > For the PMX card work properly, please follow the
            instructions below :

          1. Determine which Network OS the machine used.

          2. Read the user's manual in the driver disk and modify some of

             system information files, such as "AUTOEXEC.BAT", "CONFIG.SYS",

             "PROTOCOL.INI", if necessary.

          3. copy the proper network driver(s) from driver disk to the desired

             directory.