1. networkcards.zip Driver
2. README.TXT File Contents

README.TXT Driver File Contents (networkcards.zip)

   Microsoft LAN Manager 2.1 Installation Guide with Samsung NDIS 2 Driver
   =======================================================================


This document describes how to install Microsoft LanManager 2.1 Work-
station with the Samsung NDIS 2 driver.

1. Execute SETUP from the MS LanManager DOS Setup 2.1. After  
   copying files from the two Microsoft disks, Network Adapter Drivers 
   is displayed. Select <Other Driver> at the bottom of the screen.

2. Insert the Samsung PCI driver disk and type A:\ (even though the driver
   is in \MSLANMAN.DOS\DRIVERS\ETHERNET\SEC) and press Enter.

3. The Other Network Adapter Drivers window appears with Samsung PCI
   Ethernet Adapter as an option. Click OK.

4. Select the protocol you want to use (NetBeui or TCP/IP) from the  
   Network Protocols for Samsung PCI Ethernet Adapter window.

5. Select and run LanManager with the Windows environment then proceed to
   complete the installation.

6. Restart the computer.


 WARNING: Make sure you use the latest EMM386.EXE. If MS LanManager
          uses the old version of EMM386.EXE, it will cause the computer
          to hang on reboot.

Sample files for PROTOCOL.INI, SYSTEM.INI, CONFIG.SYS, AUTOEXEC.BAT are
listed below:

PROTOCOL.INI:
=============
         [PROTMAN]
           DRIVERNAME = PROTMAN$
           DYNAMIC = YES
           PRIORITY =NETBEUI
         [NETBEUI_XIF]
           DRIVERNAME =NETBEUI$
           SESSIONS = 6
           NCBS = 12
           BINDINGS = "SEC100_NIF"
           LANABASE = 0
        [TCPIP_XIF]
           DRIVERNAME =TCPIP$
           IPADDRESS = 192 XXX XXX XXX
           SUBNETMASK0 = 255 255 255 0
           DEFAULTGATEWAY0 =
           NBSESSIONS = 6
           LOAD = TCPTSR[C],TINYRFC[C],EMSBFR[CR]
           UNLOAD = UNLOADT /NOTSR[DC]
           BINDINGS = "SEC100_NIF"
           LANABASE = 1
        [SEC100_NIF]
           DRIVERNAME = SEC100$
	   NODE_ADDRESS = '222222222222'

SYSTEM.INI;
===========
        [BOOT]
        ......
        NETWORK.DRV=LANMAN21.DRV
        .....
        [BOOT.DESCRIPTION]
        NETWORK.DRV=LAN MANAGER 2.1 ENHANCED NETWORK
        SECONDNET.DRV=NO ADDITIONAL NETWORK INSTALLED

CONFIG.SYS:
===========
        DEVICE=C:\LANMAN.DOS\DRIVERS\PROTMAN\PROTMAN.DOS /I:C:\LANMAN.DOS
        DEVICE=C:\LANMAN.DOS\DRIVERS\ETHERNET\SEC\SE100NDS.DOS
        DEVICE=C:\LANMAN.DOS\DRIVERS\PROTOCOL\TCPIP\TCPDRV.DOS /I:C:\LANMAN.DOS
        DEVICE=C:\LANMAN.DOS\DRIVERS\PROTOCOL\TCPIP\NMEM.DOS

AUTOEXEC.BAT:
=============
        SET PATH=C:\LANMAN.DOS\NETPROG;%PATH%
        C:\LANMAN.DOS\DRIVERS\PROTOCOL\TCPIP\UMB.COM
        NET START WORKSTATION
        LOAD NETBEUI
        LOAD TCPIP
        (The last two statements are for the Protocols you want to use.
        Therefore you might see more or less depending on the situation)