Ether16 LAN Card Setup for 3Com 3+ Share ----------------------------------------------------------------- Contents: Before You Begin Setup Technical Support -------------------------------------------------------------------------- BEFORE YOU BEGIN -------------------------------------------------------------------------- If your computer does NOT have a plug-and-play motherboard, the following notes apply to you: 1. Before attempting to install the Ether16 LAN Card's network software drivers, you MUST configure the card's internal settings with the SETUP program included on Ether16 disk 1 under the UTILITY directory. Use the program to set the card's interrupt (IRQ) and I/O settings. For directions on using SETUP, see your Ether16 user guide. 2. Most network software packages like Windows 95, Windows NT, Novell NetWare, etc., include a "generic" network driver that will work with a wide range of network cards. This generic driver is called a "Novell NE2000" compatible driver, and it is fully supported by the Ether16 card. If your network software package asks you to choose the name of the network card you're installing from a list of available adapters, and you find "NE2000" or "Novell NE2000" listed, you don't need to follow the directions below---simply choose to install the NE2000 driver and the Ether16 Card will be ready for use. THE ETHER16 IS ONLY NE2000 COMPATIBLE WHEN THE CARD'S PLUG-AND-PLAY MODE IS TURNED OFF. If your PC has a plug-and-play motherboard, and you wish to use the generic NE2000 driver, you must run the Ether16 SETUP program and turn the card's plug-and-play mode off. Setup ----------------------------------------------------------------------- Install the 3Com software. When asked for the name of the network adapter or card to install, choose the 3Com EtherLink board. Copy the ETH.SYS file from the PKTDRV directory of the Ether16 disk1 to your boot disk. Make sure that the CONFIG.SYS file of the boot disk uses the following lines: DEVICE = ETHER.SYS </d> </w> <packet_int_no> DEVICE = ETH.SYS ...where... <packet_int_no> is the software interrupt vector number used by the packet driver program. This can be from 96 to 128. /d Delay Initial - The driver program will not initialize the network interface card until the packet driver program is accessed by its upper layer program. /w The -w parameter is for use only in the Windows environment. You may now reboot and to start 3COM workstation. HOW TO GET TECHNICAL SUPPORT ------------------------------------------------------------------------ There are a variety of methods that you can use to get FREE technical help or sales information about Linksys products. Support Hotline (949) 261-1288 Fax (949) 261-8868 BBS (949) 261-2888 (8-N-1) E-mail support@linksys.com World Wide Web http://www.linksys.comDownload Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.