3Com (R) Corporation
EtherDisk (R) Diskette for
The EtherLink 10 ISA NIC Family
Clarkson Packet Driver
The EtherLink 10 ISA family of NICs are all software configured.
When the packet driver is loaded the only required command line
parameter is the software interrupt value `PKT_INT_NUM.' This
software interrupt is used for communication between the driver and
the protocol and should not be confused with the NIC's hardware
interrupt. As of version 1.09 of the Packet Driver Specification
valid software interrupt values are in the range 0x60 to 0x80.
The packet driver for the EtherLink 10 ISA is a DOS mode driver that
does not support plug and play. Plug and play must be disabled on the
EtherLink 10 ISA, and this can be done by running PNPDSABL.BAT from
the second diskette of the 6.1 driver set.
The packet driver for the EtherLink 10 ISA does not support auto-media
sensing. The driver will default to the media programmed on the NIC.
The default is "Twisted Pair" when the adapter is shipped. The NIC can
be forced to the appropriate media by running the configuration utility,
3C5X9CFG.EXE, from the second diskette. Refer to the manual for
instructions on configuring the 3C509B NIC.
The SLOT and IOBASE parameters are to be used only when there is
more than one EtherLink 10 ISA board in the machine. This parameter
indicates to the packet driver which NIC to use. For NICs in ISA mode,
use the IOBASE parameter. On Microchannel NICs, EISA NICs, or ISA NICs
in EISA mode, use the SLOT parameter. You cannot use both IOBASE and
SLOT on the same command line.
EXAMPLE: You have two EtherLink 10 ISA NICs in your machine.
One is installed at I/O Base 300 hex and the other at 320 hex. To
use the card located at 300 hex and load it at software interrupt
60 hex for use in a Windows environment, use the command line:
3C5X9PD -w 0x60 IOBASE=0x300
For a complete usage summary, enter 3C5X9PD at the DOS command prompt.
(%VER PACKET.TXT - Packet Driver v6.1b)
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.