UDMA UDMA33/66/100 change Utility for HN14L/PB16/HN15L series.
File name:udma100c.exe
0) Copy the udma100c.exe file to MS-DOS FDD.
1) Connect target drive to ATA bus.
2) Turn on drive power and PC by MS-DOS FDD.
3) To start this tool, type following filename at command prompt.
A:\> UDMA100C 33 (for UDMA33 mode setting)
or
A:\> UDMA100C 66 (for UDMA66 mode setting)
or
A:\> UDMA100C 100 (for Ultra DMA100 mode setting)
New setting will be valid after power off -> on.
//////////////////////////////////////////////////////////////////////
// //
// UDMA Support Level Revising Utility for fujitsu drive. //
// PB16/HN14L/HN15L Series - UDMA100 supported drive Only. //
// Firmware Development, IDE-fw project. Hirotaka.Iima //
// Copyright(C) FUJITSU Ltd. 1999-2001, All rights reserved. //
// //
//////////////////////////////////////////////////////////////////////
Version 1.19 Oct.23, 2001
Usage : UDMA100C [33 or 66 or 100]
Option: [/Master or /Slave], [/PRI or /SEC]
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.