1. Compaq_Netelligent_10_or_10_100_Controller_PCI.zip Driver
2. MSNFT.TXT File Contents

MSNFT.TXT Driver File Contents (Compaq_Netelligent_10_or_10_100_Controller_PCI.zip)

   3 Windows NT Network Fault Tolerance
                                                           v1.0

Network Fault Tolerance installation notes for the
Compaq Netelligent 10/100 Controller under Windows NT 4.0
============================================================

Overview
--------
Network Fault Tolerance provides link redundancy for two
Netelligent 10/100 Controllers.  When configured, there becomes 
a primary and secondary Netelligent 10/100 Controller. If the primary
loses communication with the hub/switch, the secondary automatically 
takes over.  The secondary controller will take over for such 
reasons as cable connection problems, switch or hub port
failure or controller failure.  For more information on controller
fault tolerance please see the readme file Network Fault Tolerance
readme file.
     
     

Before you get started
----------------------

Before you can configure the Netelligent 10/100 controller for Network Fault 
Tolerance, you need to do the following:
      
      Install two Netelligent 10/100 controllers in a Windows NT 4.0
      system as described in the readme file MSNT40.TXT. When
      installation is complete make sure you restart NT.
      
      If connecting to a hub, each Netelligent 10/100 controller in a team 
      will need to be connected to a separate port, which is
      in the same collision domain.  If connected to a switch,
      each Netelligent 10/100 controller in a team will have to be connected 
      to a separate port which is in the same network.


General Instructions
--------------------

1. Double-click on the Network Icon in the Control Panel.

2. Select the Adapter tab and double-click the "Compaq
   Netelligent 10 or 10/100 PCI Intel Controller" found in the Network
   Adapters list box.  This will launch the Compaq CPQSET utility.

3. Click on the Fault Tolerance button.

4. The Compaq Network Fault Tolerance dialog box appears.  Click
   OK to continue. Network Fault Tolerance will automatically be
   installed.

5. To complete the configuration and installation, you will need
   to click the Close button in the Network dialog box.  This
   will update the bindings and allow you to assign the controllers
   to an Network Fault Tolerance team.

6. The dialog box Compaq Network Fault Tolerance Configuration
   Manager is displayed during the binding process after the
   Close button is clicked.  Follow the directions on the screen
   to assign Netelligent controllers to the Fault Tolerance team.
   When done click OK to continue.
      
      Note: If you are creating more than one Network Fault
            Tolerance team, do not restart NT until all teams are
            created.

7. To add additional Network Fault Tolerance teams, repeat this 
   process starting at step 1.


Additional Information
----------------------

Launching the Configuration Manager:
   
   To launch the Compaq Network Fault Tolerance Configuration
   Manager, go to the Control Panel and select the Adapters tab in
   the Network dialog box.
   Highlight the Compaq Network Fault Tolerance Team and select
   Properties.

Identifying the Properties of the Compaq Network Fault Tolerance
team:
   
   In the Compaq Network Fault Tolerance Configuration Manager,
   highlight the Compaq Network Fault Tolerance team and click
   Properties.  See Help for more detailed information about the
   settings.

Identifying the Properties of a Netelligent controller in a Fault 
Tolerance team:
   
   In the Compaq Network Fault Tolerance Configuration Manager,
   highlight the Compaq Netelligent 10 or 10/100 PCI Intel Controller and 
   click Properties.
   See Help for more detailed information about the settings.



*  Third-party trademarks are the property of their respective owners.