1. allkeydisk.zip Driver
2. Readme First.txt File Contents

Readme First.txt Driver File Contents (allkeydisk.zip)

Thank you for using The AllKEY. (Ver. 1.06.06)

1: You need to install the driver (TSUsbKey.inf) and check hardware manager if The AllKEY USB key      is ready before you use the application.

2: When you plug in "The AllKEY" first time you will be asked to type Key ID and password. The Key      ID is labeled on the CD-ROM and you type your own password .Please keep the Key ID and Password     well!    You might duplicate the same new Key if the old Key was lost. 

3: To Make sure your USB Key connect directly to motherboard USB port (Do not connect to any other     USB Hub) when using PC Lock function otherwise will cause system boot up failure. 

4: We do not recommend that user to use PC Lock function when many people using the same one           computer. The computer may be confused by different USB key and cause the system boot up            failure.


5: In WinXP, Win2000 and WinME operation systems please do not remove USB Key directly from USB        port otherwise the virtual hard disk drive will not go away sometimes. It is better to follow       the safety hardware removal procedure to stop "The AllKEY ".

6: In Win98SE and WinME you need to press F5 (refresh) to see the virtual hard disk.

7: The maximum space is 2GB per partition for Win98SE and WinME. In Win2000 and WinXP the maximum      space is 4GB per partition.

8: When you backup the image file to CD-ROM just burn ***.img will be OK.

9: Web Lock function only supports Microsoft Internet Expore 6.0 or above.

10: Each USB Key can adds four partitions at most.

IMPORTANT:
If you lost your original key please get another new key to duplicate it with the same Key ID and Password. This new key can restores your image data to prior partition drive you made before.