1. flsh1622.exe Driver
2. README.txt File Contents

README.txt Driver File Contents (flsh1622.exe)

************************************************************
************************************************************
**                                                        **
**                       WARNING!!!                       **
**                                                        **
**     If these instructions are not followed exactly,    **
**     your drive may become inoperable.  Please print    **
**     out this document so that you can refer to it      **
**     during the upgrade process.                        **
**                                                        **
************************************************************
************************************************************





************************************************************
*                 FLASH.EXE (Version 1.00)                 *
*         CD-Recordable/Rewritable Firmware code           *
*               Flash PROM upgrading Utility               *
************************************************************

Objective
*********
This file provides information on the usage of flash PROM programming utility FLASH.EXE.

Warning!
********
This utility is only for upgrading the flash PROM. The instructions should be followed 
exactly as printed. It could cause your flash PROM in the drive to be corrupted if not 
used properly.


Usage of FLASH.EXE
******************
This program requires DOS environment to function properly.

If you are using Windows 95, please restart your system by clicking [Start] [Shut Down] and 
[Restart the computer].  When you see the message "Starting Windows 95...", press the "F8" key 
and select "Safe Mode Command Prompt Only".

If you are using Windows 98, please restart your system by clicking [Start] [Shut Down] and 
[Restart the computer].  Press and hold the "CTRL" key until you see the Start-Up Menu and 
select "Safe Mode Command Prompt Only".

If you are using Windows NT, please use a DOS boot disk.

Put the flash BIOS disk into your floppy drive. We are assuming it is A:.  (This is the disk 
that was created when you double-clicked the FLSH1622.EXE program.)

(1) At the C:\ prompt, type A: then press Enter.

(2) At the A:\ prompt, type FLASH.EXE and press Enter.

(3) Highlight [Drive Selection] and press Enter.
Select the location of the drive (Primary Master (usually hard drive), Primary Slave, 
Secondary Master, Secondary Slave).  If you don't know the location of the drive, try each 
choice until it sees the Memorex CRW-1622.  You can check if the [Current Drive Selected] 
indicates the drive that you want to upgrade the BIOS (e.g. Memorex CRW-1622).

(4) Next, select [Download Firmware] and press the Enter key.
The program will prompt you if you want to download the flash code without asking you to 
make any selection.

Follow prompts along the way to hit any key.

Then the program will proceed to download the code into drive and will show you a checksum 
if file successfully downloaded.

(5) Finally, select [Quit This Program] and Reboot the system by switching off and on power 
switch as warm reboot will not reset the drive. The drive will boot with the new firmware code 
after this.