; ENABLE Configuration File ; ; MEMORY specifies the memory location to be used to enable the ; card. If using Card Services, have the same address specified ; that it uses. If using SE as a point enabler, you will need to ; have your memory manager exclude the memory range you will use. ; You should exclude a 4K block. For example, if you were using ; the memory location 0xD000, you could exclude the 4K block for ; EMM386 by adding the flag X=D000-D0FF to the driver line for it. ; [MEM] Memory=0xD000 ; The following parameters specify what resources will be used by ; the modem. The resources will be allocated to the first modem ; that is found. (Additional modems will be ignored.) ; ; If the card found is a combo card, and there are valid modem ; parameters specified by the "ComboFile" networking file, those ; values will be used instead. ; [MODEM] ModemPort=2 ModemIRQ=3 ; The LAN resources are kept in a separate file to be used by the ; drivers. To modify the resources allocated to the LAN card, ; you can modify the indicated file. ; ; This file will probably be either NET.CFG or PROTOCOL.INI. ; If the configuration file being used by your networking drivers ; is different from the one specified below, you should update ; this parameter. (This will often be the case with the ; PROTOCOL.INI file.) ; [LAN] LanFile= ; The Combo Card resources are kept in a separate file to be used ; by the drivers. To modify the resources (both LAN and modem) ; allocated to the combo card, you can modify the indicated file. ; ; This file will probably be either NET.CFG or PROTOCOL.INI. ; If the configuration file being used by your networking drivers ; is different from the one specified below, you should update ; this parameter. (This will often be the case with the ; PROTOCOL.INI file.) ; [COMBO] ComboFile= ; NUMSLOTS can be used to specify the maximum number of slots ; that the computer has, or that the user desires to support. ; ENABLE will ignore this value if it finds the computer has ; less slots than the number specified. If this value is not ; specified, ENABLE will attempt to detect the number of PC Card ; slots your computer has. ; ; ENABLE will support up to 8 slots. ; [SLOTS] NumSlots= ; IGNORESLOT can be used to specify any slots that we will not ; support. This will allow the user to have non-Megahertz cards ; in these slots. ; ; For this parameter, slots are labeled A, B, C, etc. ; [IGNORE] ; BADPORT, BADBASE, BADIRQ and BADMEMORY are used to keep track of ; resources that we might think are available, but found out later ; that they really are not. This section will probably be blank ; unless we have run INSTALL more than once because of a failure. ; If there is more than one item of a given type that is bad, ; the items should be separated by commas. ; [BAD]Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.