SyncI/O Installation
1. Remove your STUDI/O card from your computer.
2. Connect the SyncI/O Sync back plate to your STUDI/O card with the
supplied ribbon cable. The cable runs from the header labeled
"To StudI/O" on the SyncI/O board to the header labeled "ADAT SYNC"
on the STUDI/O card. Pin 1 is indicated by a triangle printed on
the circuit boards near both headers.
3. Replace the STUDI/O board in your computer and turn it on.
4. After Windows95 boots, double click on the supplied "syncio.reg" file.
This will cause the necessary registry setiings to be place in your
computer's registry.
5. Reboot your computer again.
6. Now you may enable the MTC port in the settings tab of your STUDI/O
board's Properties page, if so desired. This is accessable through the
device manager.
7. If you have more than one STUDI/O installed in your computer, disable
the MTC port on all but one device.
NOTE: SEE OUR WEB SITE FOR PICTORAL INSTALLATION GUIDE AND APPLICATION NOTES
http://sonorus.com/appnotes.html
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.