Nov 1995
EZ2000+ Series Ethernet Card Setup/Diagnostic program
=======================================================
The EZ2000.EXE program (Setup/Diagnostic) lets you configure the EZ2000+
hardware settings, and test the state and cable connection of the card.
To run the program, insert the EZ2000+ driver program diskette in drive
'A' and do the following:
> cd \UTILITY --change directory to UTILITY
> EZ2000 --run the EZ2000.EXE program
or
> cd \UTILITY --change directory to UTILITY
> EZ2000 /F --run the EZ2000.EXE with parameter /F
if the data in your EEPROM has been corrupted
or you cannot configure your card through
normal procedure.
or
> cd \UTILITY --change directory to UTILITY
> EZ2000_d --run the EZ2000 with parameter _D
this parameter lets you Setup the EZ2000+ by
reading EZ2000.DAT file. This way, you can
quickly configure your card without going
through the menus.
Menu Options
============
1. EZ2000 lets you configure the hardware settings of EZ2000+.
You have the option to view/change :
. Connector Type
. I/O Base Address
. Interrupt Number
. Remote Boot
2. EZ2000/F lets you configure your card if the data in your EEPROM
has been corrupted or your cannot configure your card through
normal procedure.
. Node ID
. Bus Mode
. Card Type
. I/O Base Address
. Interrupt Number
. Remote Boot
3. EZ2000_D lets you configure the card in non-interactive mode by using
the _D switch. The EZ2000+ program will automatically read the text file
EZ2000.DAT located in the same directory. The following is an example:
. Connector Type UTP
. I/O Base Address 0x300
. Interrupt Number 5
. ROM Size 16k
. ROM Address 0xD000
Note:
1. Setup will only change the setting that appears in EZ2000.DAT, and other
setting will not be changed.
2. If any setting about boot ROM (ROM Size or ROM Address) appeared,
boot ROM will be set to 'Enable'. Otherwise it will set to 'Disable'.
3. If connector type is not configured, the driver will automatically
detect the active media connector.
4. DIAGNOSTIC lets you diagnose the state and cable connections of EZ2000+.
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.