1. tl-6200i.exe Driver
2. README.TXT File Contents

README.TXT Driver File Contents (tl-6200i.exe)

          NDIS Driver Installation Guide for Banyan VINES client
       ============================================================

Introduction
============
    This document describes the procedure to install NDIS 2.01 driver on
    "Banyan VINES" DOS client.

    This driver conforms to the Network Driver Interface Specification
    (NDIS 2.01) defined by Microsoft/3Com.


Installation Procedure
======================

    1.  Use the DOS MD command to create a subdirectory called \VINES.

    2.  Copy the contents of the VINES LAN S/W (DOS) Install diskette
        into the \VINES subdirectory.

    3.  Copy the contents of the NDIS subdirectory on the VINES LAN S/W
        (DOS) 2 of 2 diskette into the \VINES subdirectory.

    4.  Copy the DC21X4.DOS file from \LANSRVR\DOS sub-directory on the
        driver diskette to the \VINES subdirectory.

       Note : The DC21X4.DOS driver is under \LANSRVR\DOS sub-directory.

    5.  Edit the PROTOCOL.INI file as follows:

        [PROTOCOL MANAGER]
          DRIVERNAME = PROTMAN$

        [VINES_XIF]
          DRIVERNAME = NDISBAN$
          BINDINGS = DC21X4_NIF

        [DC21X4_NIF]
          DRIVERNAME = DC21X4$
          SIA_Mode = AUTOSENSE

    6.  Run the PCCONFIG.EXE program located in the \VINES subdirectory.

    7.  Select option 1, Network Card Settings.

    8.  Select the "NDIS Ethernet" option.

    9.  The NDIS workstation screen appears. Enter the IRQ that you
        selected for the 10/100 Mbps PCI Fast Ethernet adapter.

   10.  Press 'F10' when done, press <ESC> to exit this screen.

   11.  Select "2 - Login Environment Settings. ", Press <Enter>.

   12.  Select "1 - Select Default Communications Driver. ", Press <Enter>.

   13.  Choose "NDIS Ethernet", Press <ESC> to exit this menu.

   14.  Edit the CONFIG.SYS file and add the following lines, substituting
        A: for C: for a floppy diskette installation.

        DEVICE = C:\VINES\PROTMAN.DOS /I:C:\VINES
        DEVICE = C:\VINES\DC21X4.DOS

   15.  Add the BAN command to the AUTOEXEC.BAT file.  BAN loads the NDISBAN
        drivers and reads the PCCONFIG.DB file to invoke changes made during
        the PCCONFIG stage.