1. tl-6200i.exe Driver
2. README.TXT File Contents

README.TXT Driver File Contents (tl-6200i.exe)

         Driver Installation Guide for MS LAN Manager v2.x (DOS)
        ********************************************************

Introduction

    This document describes the procedure to setup NDIS 2.01 driver on
    LAN Manager v2.x DOS Workstation.

    This driver conforms to the Network Driver Interface Specification
    (NDIS 2.01) defined by Microsoft/3Com.


Installation Procedure


 A. Suppose you install MS LAN Manager on a DOS workstation for the
    first time.

    1. Execute the "SETUP.EXE" program that is provided by LAN Manager.
       Upon completion of retrieval of the last workstation disk's
       contents, you will be asked if you want to import additional
       network drivers.  Answer "YES".

    2. Insert this diskette into the floppy drive.

    3. Follow the instructions on the screen. "SETUP.EXE" program will
       retrieve NDIS driver programs from the diskette and put them on
       the harddisk and directory where LAN Manager resides.

    4. After completion of the setup procedure,  your CONFIG.SYS file
       will contain statements for the DC21X4.DOS NDIS driver programs
       as sample file.

    5. Reboot your computer and follow NDIS binding procedure to use
       the DC21X4.DOS NDIS driver programs.


 B. If you have installed LAN Manager in your harddisk.

    1. Execute the "SETUP.EXE" program.

    2. On the screen, select 'Configuration', 'Network Drivers', 'other
       Drivers' function and input correct diskette driver name.

    3. Insert driver diskette into the floppy drive.

    4. Follow the instructions on the screen. "SETUP.EXE" program will
       retrieve all NDIS driver programs from the driver diskette and
       put them on the directory where LAN Manager resides.

    5. After completion of the setup procedure,  your CONFIG.SYS file
       will contain statements for the DC21X4.DOS NDIS driver programs.

    6. Reboot your computer and follow NDIS binding procedure to use
       the DC21X4.DOS NDIS driver programs.


    --- Sample CONFIG.SYS file ---

          :
        DEVICE=C:\LANMAN.DOS\DRIVERS\PROTMAN\PROTMAN.DOS /i:C:\LANMAN.DOS
        DEVICE=C:\LANMAN.DOS\DRIVERS\ETHERNET\DC21X4\DC21X4.DOS
          :


    --- Sample PROTOCOL.INI file ---

        [PROTMAN]
          DRIVERNAME = PROTMAN$
          DYNAMIC = YES
          PRIORITY = NETBEUI

        [NETBEUI_XIF]
          Drivername = netbeui$
          SESSIONS = 6
          NCBS = 12
          BINDINGS = "DC21X4_NIF"
          LANABASE = 0

        [DC21X4_NIF]
          DRIVERNAME = DC21X4$
          SIA_Mode = AUTOSENSE