1. TD8v110.zip Driver
2. readme.txt File Contents

readme.txt Driver File Contents (TD8v110.zip)

***TD-8 System Update Procedure***

**Note:  All Custom Data and settings will be lost when updating the TD-8's operating system.  Please backup all important information.

*Tools needed*
1.  TD-8
2.  Update disk with SMF files	
3.  MIDI cable
4.  Sequencer capable of playing SMFs

*Update Procedure*

1. Connect MIDI out of the sequencer to MIDI In on the TD-8

2. Power on while holding [SETUP]+[REC], and you will
enter Update Mode. [SETUP] will light.

*Note: If you make a mistake in the order of the following procedure, the TD-8 will start up in its normal mode.

3. Continue holding [REC], release [SETUP], and press [DOWN].
[CHAIN] will light.

4. Continue holding [DOWN], release [REC], and press [BWD].
When [CHAIN] and [REC] light, release the buttons.
If a FlashID error occurs, [CLICK] will light.
Press any of the buttons, the TD-8 will start up in normal
mode.

5. When [CHAIN]+[REC] go dark and [PLAY] lights, play back the
update disks in the correct order.

During the update, the TD-8 will operate as follows.
..5-1 While receiving data, [TRIGGER] will light.
..5-2 While writing data, [REC] will light.
..5-3 When writing is completed and the unit is waiting to receive data,
[PLAY] will light
Repeat steps 5-1 ~ 5-3 for each SMF

6. After sending all files, [KIT] will blink, indicating
that the update process has ended successfully

7.  Power off the TD-8
8.  Turn power on to return to normal operation