1. MEMPDRVR.EXE Driver
2. README.TXT File Contents

README.TXT Driver File Contents (MEMPDRVR.EXE)

  Memory Plus Expansion Adapter Driver (250-2062)

This driver enables the TANDY 1000 EX and 1000 HX computers to 
utilize the additional 128K of memory on the Memory PLUS Expansion 
Adapter as a RAM disk.


This disk contains the following files--

   DISKNEM.SYS
   README.TXT

In order to obtain a printout of this README.TXT file, insert this
disk in Drive A, make sure that your printer is switched on, is on
line, and at the C:\> prompt, type the following command--

   PRINT A:README.TXT

and press <Enter>.


INSTALLATION

1.  Start up your computer, with the MS-DOS disk in Drive A.

2.  At the A:\> prompt, type

       EDLIN CONFIG.SYS

    and press <Enter>.

3.  Type

       1I

    and press <Enter>.

4.  At the 1:* prompt, type 

       DEVICE=DISKMEM.SYS

    and press <Enter>.

5.  Press <CTRL>-<BREAK>.

6.  Press <E> and <Enter>. The A:\> prompt will be displayed on the
    screen.

7.  Insert this disk in Drive B. If it is a computer with one drive,
    replace the MS-DOS disk in Drive A with this disk.

8.  In a two drive computer, type

       COPY B:DISKMEM.SYS A:

    and press <Enter>. For a single-drive computer, with this DISKMEM
    disk in Drive A, type

       COPY A:DISKMEM.SYS B:

    and press <Enter>. Respond accordingly to the prompts to switch
    disks.

9.  After DISKMEM.SYS is copied to the MS-DOS Disk, restart your 
    computer. When booting, a message which indicates that the
    RAM Disk is installed is displayed.
                  

NOTE:
   * For additional information on the Memory PLUS Expansion Adapter,
     refer to the Installation and Operating Instructions Manual for
     this adapter.



NOTE:
"While reasonable efforts have been taken in the preparation of this
information to assure its accuracy, Tandy Corporation/Radio Shack
assumes no liability resulting from the use of the information
contained herein."