1. 220-0182.EXE Driver
2. README.TXT File Contents

README.TXT Driver File Contents (220-0182.EXE)

SOFTWARE FOR DIGITAL MULTIMETER WITH COMPUTER INTERFACE
version 1.21

The software provided with the Digital Multimeter is designed to receive,
record, and graphically present Digital Multimeter (DMM) measurement data.
This software can be run both under MS-DOS as well as Windows. The DOS
program is called RS and is in the directory called GRAPHIC. The Windows
program is called SCOPEVIEW located in the SCOPE directory.

This disk contains the following files--

   README.TXT
   GRAPHIC <DIR>     SCOPE <DIR>
   RS.EXE            VBRUN300.DL_
   README.TXT        SETUP.EXE
   ENGLISH.FNT       SETUP1.EX_
   CONFIG.INI        VER.DL_
   SAMPLE.3UT        README.TX_
                     SETUPKIT.DL_
                     SETUP.LST
                     RS.EX_
                     RS.IN_
                     THREED.VB_
                     DDEML.DL_

In order to obtain a printout of this README.TXT file, insert this disk 
in Drive A, make sure your printer is switched on, is on line, and at the
C:\> prompt, type the following command--

   PRINT A:README.TXT

and press <Enter>.


INSTALLATION FROM MS-DOS

   1.  Connect the Multimeter to your computer's COM port as instructed
       in the owner's manual for the Multimeter.

   2.  Start up your computer.

   3.  Insert this disk in Drive A.

   4.  At the C:\> prompt, type

          MD \METER

       and press the <Enter> key.

   5.  Type

          COPY A:\GRAPHIC\*.* METER

       and press <Enter>.

NOTE:
   In order to run the program, at the C:\> prompt, type

      RS

   and press <Enter>.  Respond accordingly to the instructions in the
   on-screen help.




NOTES:
   * If your computer does not have a hard disk, the program can still be
     run from this diskette. Insert this disk in Drive A, enter A:, enter
     CD \GRAPHIC, and enter RS.
   * To stop the program or to escape from a Device I/O Error, press
     <Ctrl>-<Break>.


INSTALLATION FROM WINDOWS

   1.  Connect the Multimeter to your computer's COM port as instructed
       in the owner's manual for the multimeter.

   2.  Start up your computer.

   3.  At the C:\> prompt, type

          CD \WINDOWS

       and press <Enter>.

   4.  Type

          WIN

       and press <Enter>.

   5.  At the Program Manager screen, click on File.

   6.  Click on Run.

   7. At the Command Line prompt, type

         A:\SCOPE\SETUP

      and press <Enter>.


NOTE:
   In order to run the Scopeview software, turn the meter on, click on
   the newly-created Scopeview icon, and respond accordingly to the
   prompts.  Refer to the Scopeview manual for a description of the 
   various Setup Option choices as well for the different modes of
   gathering data.


NOTE:
"While reasonable efforts have been taken in the preparation of this
information to assure its accuracy, Tandy Corporation/Radio Shack
assumes no liability resulting from the use of the information
contained herein."