1. AF595_Win_1_11_DR.exe Driver
2. INSTALL.TXT File Contents

INSTALL.TXT Driver File Contents (AF595_Win_1_11_DR.exe)

              Driver Installation Guide for Windows NT 5.0
           ==================================================

Introduction
============
    This document describes the procedure to install NDIS 5.0 driver on
    Windows NT 5.0 for FriendlyNET PCI595 Fast Ethernet Adapter.

    Location of Driver: \WIN2000\SISNIC.SYS


Installation procedure
======================
    1. Install the card in one of PCI slot and connect the cable to the
       network; turn on the computer and start Windows NT.

    2. When Windows NT starts, a "Found New Hardware Wizard" dialog box
       appears identifying the card as a "Ethernet Controller";  Select
       "Search for a suitable driver for your device [Recommended]".

       If the "Found New Hardware Wizard" dialog box does not appear,
       Windows NT fails to detect your adapter. There may be problem
       with the adapter itself or with the system BIOS.

    3. Click Next then only enable the "Specify a location" check box;
       Insert the FriendlyNET PCI595 PCI drivers diskette in drive A:

    4. Click Next then specify correct driver path, e.g. A:\WIN2000.

    5. Click Ok then Windows NT will indicate that it will install the
       driver using A:\WIN2000\NETSIS.INF

    6. Click Next to let Windows NT finishes the driver installation.


Adapter Configuration
=====================
    1. Double click "My Computer".

    2. Double click "Control Panel".

    3. Double click "System" icon.

    4. Click "Hardware" tab then click "Device Manager..."

    5. Open "Network Adapters" icon.

    6. Double click "FriendlyNET PCI595 Fast Ethernet Adapter [NDIS5]"
       then a properties page appears.

    7. Click "Advanced" tab.

    8. Here, you can set the following properties:

       a. MediaType:
          ----------
          100BaseTX
          100BaseTX Full_Duplex
          10BaseT Full_Duplex
          10BaseT
          AUTO_CONFIG   ;Default value if not set

       b. NetworkAddress:
          ---------------
          Override the adapter's Ethernet address. Legal values are
          xx-xx-xx-xx-xx-xx, where xx is a hexadecimal byte value.
          Unless necessary, do NOT modify this field and let the system
          use the default Ethernet address contained in the serial ROM
          on the adapter.