1. aon101v2.1.zip Driver
2. SCO5.TXT File Contents

SCO5.TXT Driver File Contents (aon101v2.1.zip)

   SCO UNIX

   Introduction:
   -------------
      This document describes the procedure to install the SCO UNIX driver
      for AOpen AON-101 10M ISA PnP Ethernet Adapter.

   Location of Driver:     \SCO5\DRIVER.O
   ------------------

   The following files will be used in this installation:
   ------------------------------------------------------

      driver.o    :  AON101 MDI Driver Program
      setup       :  Transfer dos format to unix format setup program
      master      :  Used by netconfig
      system      :  Used by netconfig
      node        :  Used by netconfig
      space.c     :  Used by netconfig
      space.h     :  Used by netconfig
      lkcfg       :  Used by netconfig
      AOF/r2e     :  Used by netconfig


   Installing driver procedure on SCO UNIX :
   ----------------------------------------
      Before you start with the installation  process,  make sure that the
      SCO UNIX system is properly installed. Similarly,your adapter should
      also be properly installed in your machine.

      1. Login as root user. (On maintenance mode)

      2. Put AOpen SCO UNIX Driver diskette to floppy A: and use doscp
         command to copy the file "setup" for installing AOpen SCO UNIX
         Driver into UNIX's directories as following :

             # cd /
             # doscp A:/sco5/setup /setup
             # chmod +x /setup
             # ./setup

      3. Use netconfig utility
         Avaiable options :

             # netconfig

      4.  To add adapters, select "Add New Lan Adapter" from "Hardware".

      5.  Select "AOpen AON-101 10M ISA PnP Ethernet Adapter Driver" from list.
      
         NOTES: If you ever used old AON101 driver, you can find the description
           "AOpen AON-101 10M ISA PnP Ethernet Adapter Driver, board 0".
           Now please ignore it or you also can remove it from list
           using below method:

           # cd /usr/lib/netconfig/info
           # rm r0e0


      6.  Add Protocol to select SCO TCP/IP. 
       
      7.  Enter the internet Address of this interface    n.n.n.n

      8.  Enter the netmask for this interface            (default 255.255.255.0)

      9.  Enter the boardcast address for this interface  default: n.n.n.n

     10.  Do you want to relink to kernel now ?           y

     11. Do you want this kernel to boot by default (y/n) y

     12. Do you want the kernel environment rebuilt (y/n) y

     13. Reboot unix

        # reboot