1. a101v22.zip Driver
2. MSLANMAN.TXT File Contents

MSLANMAN.TXT Driver File Contents (a101v22.zip)

   LAN Manager Workstation/Server

   Introduction:
   -------------
   This document describes the procedure to setup Microsoft LAN Manager
   Workstation/Server driver for AcerLAN ALN-101 PnP Ethernet
   adapter.

   Location of Driver: \MSLANMAN.DOS\DRIVERS\ETHERNET\ALN101\ALN101.DOS


   Sample Configuration Files:
   ---------------------------
      CONFIG.SYS :

          DEVICE=C:\LANMAN.DOS\DRIVERS\PROTMAN\PROTMAN.DOS /I:C:\LANMAN.DOS
          DEVICE=C:\LANMAN.DOS\DRIVERS\ETHERNET\ALN101\ALN101.DOS

      PROTOCOL.INI (will contain):

         [ALN101_NIF]
         ; ALN101 RPOTOCOL.INI SAMPLE

           DriverName = ALN101$
           AdapterID  = @006067000047 ;  This item is only required when
                                      ;  more than one ALN101 adapters
                                      ;  exist on one system.

   Setup Procedures:
   -----------------
      Before you start with the installation process, make sure that the
      adapter  is properly  installed and  configured.  Make  sure  your
      Microsoft LAN Manager is properly installed.

      1. Run the appropriate Microsoft Lan Manager SETUP for computer you
         are setting up. Select "Configuration" item ,select the
         <Other Driver> item (the AcerLAN driver isn't included on the
         LAN Manager disk) and insert the AcerLAN driver disk,specify the
         drive name of the driver disk (don't specify the path name),
         and follow the directions.

      2. When completed, reboot your computer .


   NOTES:
   ------

      1. Parameters for the PROTOCOL.INI file:

         DRIVERNAME: This is the one required parameter. See example at top
                     of this document for syntax.

         AdapterID : This  keyword is provided  by ALN101, and is  required
                     when  more  than  one  ALN101  adapters exist on one
                     system. You must modify the AdapterID value in file,
                     \LANMAN\PROTOCOL.INI, by yourself.

      2. Sample PROTOCOL.INI for LAN Manager:

           [PROTMAN]
           DRIVERNAME = PROTMAN$
           DYNAMIC = YES
           PRIORITY = NETBEUI

           [NETBEUI_XIF]
           Drivername = netbeui$
           SESSIONS = 6
           NCBS = 12
           BINDINGS = "ALN101_NIF"
           LANABASE = 0

           [ALN101_NIF]
           ;
           ; ALN101 PROTOCOL.INI Sample Adapter
           ;
           DriverName = ALN101$
           AdapterID  = @006067000047

      3. The AdapterID is the Ethernet Address of the ALN-101 Ethernet card.
         You can find the value by running ACERSET.EXE -- the View Current
         Configuration\Ethernet Address item in DOS environment.