SM7500/SM6500 Firmware Release R014
# H014 from S14.4 on Jan. 19, 1999
Adjusted the HV goal values and Added the functionaty of manually setting
white points from the control panel.
#--------------------------------------------------------------------------#
# S14.4 from S14.3 on November 13, 1997
#
# x Internal Module Firmware Revisions
# x Main Control Processor: 5.009
# x Image Enhancement Controller: 4.019
# x Input Output Controller 10.026
# x Subsystem Controller/Driver 4.007
# x Startup Diagnostics 2.002
#
# x Internal Software Component Revisions
# x Calibration: 2.10
# x Autofocus: 1.03
# x Interprocessor Communications: 2.03
# x Formatted Serial Output: 2.04
#--------------------------------------------------------------------------#
REQUIREMENTS
This release of firmware requires that the scanner EPROMs be at least
to HDC release 2 (EPROM Firmware Version E003).
Requires that the SCD board have had MDN 293 applied
#--------------------------------------------------------------------------#
Supported Features:
* SCSI interface supports FAST SCSI-II mode (10 MBytes/Sec burst)
* Full CMY/CMYK support (SM7500 only)
* Full 3x3 and 5x5 USM support (SM7500 only)
* Monochrome and single color plane scanning
* 8, 12 and 16 bit scanning modes in Mac and PC formats
* Line packed and pixel packed data presentation
* Interpolation (Bilinear and Pixel deletion/replication) to
all resolutions below 32 x native DPI (Maximum of 64K pixels per line).
* Native resolutions to 2500 DPI (8 inch drum) and 5000 DPI (4 inch drum).
* Full autofocus support.
* Full interactive focus support.
* Control panel diagnostic menu support
* Host can now determine drum size and door state.
* System startup diagnostics/Power on self test.
* Forced drum speed limit from control panel.
#--------------------------------------------------------------------------#
Known Bugs:
o If an SM6500 loses its flash memory image it will report that it
is an SM7500 Pro. This should not pose a problem as the software
has been updated to accomodate this for downloads.
#--------------------------------------------------------------------------#
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.