1. Ne10100.zip Driver
2. NDISVINE.TXT File Contents

NDISVINE.TXT Driver File Contents (Ne10100.zip)

*********************************************************************
Banyan Vines Client NDIS 2.0.1 Driver for the 
Microdyne NE10/100 ISA Adapter

Updated February 1997
*********************************************************************

If your system is not Plug and Play compatible, you must run the 
CONFIG program before starting operating system setup of 
the adapter. For more information, type GENERAL.TXT in \GENERAL
or view the Plug and Play Notes section of README - General
Introduction. CONFIG must be run under DOS.


Installation Instructions
============================

1. Create a subdirectory called VINES on your hard disk.

2. Change to the VINES subdirectory.

3. Insert the VINES INSTALL Disk into drive A or B. 

4. Type: COPY drive:*.* and press ENTER. 
drive = The floppy drive which contains the VINES Disk (A or B).

5. Insert the VINES LAN S/W (DOS) 2 OF 2 Disk into the drive.

6. Type: Copy drive:\NDIS\*.* and press ENTER.
drive = The floppy drive which contains the VINES Disk, A or B.

7. Insert the Microdyne NE10/100 ISA Adapter Disk into the drive.

8. Type: COPY drive:\MSCLIENT\*.* and press ENTER. This will copy
the NE100I.DOS file to your VINES subdirectory.

9. Run Banyan's PCCONFIG.EXE program and configure the Banyan software
to connect to the NDIS driver being used.                            
    -Select option 1 in PCCONFIG.
    -Page down the list and select NDIS ETHERNET.                   
    -Set the proper interrupt value. This value should correspond  
     with the interrupt that the NIC was configured to.            
    -Type NE100I as the section header name of the NDIS driver.      
    -Press F10 to save the configuration. Press ESC to return to
     the main menu.
    -Select option 2, LOGIN ENVIRONMENT SETTINGS.
    -Select option 1, SELECT DEFAULT COMMUNICATIONS DRIVER.
    -Page down the list and select NDIS ETHERNET.
    -Press ESC to return to the main menu.     
    -Press F10 to save your configuration and exit.

10. Edit the PROTOCOL.INI and add the header name as shown below. 

11. Edit the CONFIG.SYS and add the lines listed below.

12. Reboot the machine.                                                 

13. Change to the VINES subdirectory and run the BAN.EXE command.
Be sure you are attached to the same network as a VINES server.            
    
14. The Banyan login prompt should come up signifying a successful
connection has been established.                                    
                                                                                

Example CONFIG.SYS (Only network related files are shown)
---------------------------------------------------------

DEVICE=C:\VINES\protman.dos /i:C:\VINES                                      
DEVICE=C:\VINES\ne100i.dos      
                                                                                
Example PROTOCOL.INI                                                   
--------------------

[NE100I]                                                                       
DriverName=NE100I$


Note: To view the available keyword values supported by the 
NE10/100 adapter, go back to the main menu in README and select
Keywords or type the KEYWORDS.TXT file in the GENERAL directory.