1. 378Netware.zip Driver
2. FastTrak_readme.txt File Contents

FastTrak_readme.txt Driver File Contents (378Netware.zip)

Netware 5.1/6.0 Promise FastTrak S150 TX Series/378/TX4000 Controller Driver

**WARNING**
-  If "SYS" volume was created on the disk drive of our adapter, during the
   RAID rebuilding or checking integrity, we suggest that don't load any module 
   until duplication completed, and unload driver "FastTrak.ham" first if you need 
   to DOWN the server at that time. The reason of the suggestion is to avoid 
   system wait the critical periods causes server time out. This is because our driver
   will prevent all real mode access during critical periods.

-  If you create or delete array disk by driver utility (FastTrak SNMP) on existing 
   array disk, after doing the operation, you will have to reload (unload then load) 
   the driver to make the new array status update and function for your server.


[Installation Instructions]

------------------------------------------
To install the FastTrak driver into a NEW system
------------------------------------------

1) Access the NetWare 6.0/5.1 Operating System CD.

	choose one of 2 options for the install	

	**********
	Option 1
	**********
		Boot from CD 
		
	**********
	Option 2
	**********
		Boot from DOS partition, access the CD, and enter "INSTALL" 
	
		Make sure that the CONFIG.SYS file contains the 

		FILES=50 and BUFFERS=30 commands.

2) Select the type of installation.
3) Select regional and server settings.
4) Select the mouse and video type.
5) Select a platform support module and storage adapter.

	you need select the storage adapter to "UlSata.ham"
	
	-  From the Floppy:, highline "storage adapter" 
	       press "insert" and "F3" and then 
	       specify the path, (for example, A:\).

6) Select a storage device and a network board.
7) proceed through the installation as usual.
8) complete the installation then reboot the server.
9) Install the Support Pack if need


-----------------------------------------------
To install the FastTrak driver into an EXISTING system
-----------------------------------------------

    1. From the System Console type "NWCONFIG".

    2. Choose "Driver Options".

    3. Choose "Configure disk and storage device drivers".

    4. Choose "Select a driver".

    5. Press the INSERT key on your keyboard.

    6. Insert the FastTrak Driver Disk into your A: floppy drive.

    7. Press F3 and type "A:\" in the "Specify a directory path:" window.
       Press ENTER.

    8. The FTS150.HAM driver should be listed in the "Select a driver to
       install:" window. Press ENTER to select this driver.

    9. Choose "Yes" when asked if you want to copy this driver.