Additional instructions for uploading software to GPS25LP series sensor boards. For best results, Windows should be exited to DOS mode. On laptop PC's, battery saving timeouts should be disabled to keep the COM ports from shutting down between uploads performed by the batch file. Upload instructions: NOTE: Software is normally uploaded via the sensor board's second serial port. Units which only have access to the first serial port, or NMEA port, should refer to the section below, Uploading through the NMEA port. Following is a diagram for connecting the second serial port of a GPS25LP based unit to a PC. Refer to the technical specification for your unit to determine which pin or wire is connected to the corresponding signal below. Links to the technical specifications are located at the end of this document. PC 9 pin Female D connector GPS ----. .----- | | 2|------------------------|TXD2 3|------------------------|RXD2 | | 5|----------o-------------|GND | | | ----' | | | | power supply | | ----. | | Gnd|----------' | | | Vcc|------------------------|Vin ----' | `----- Setting Vcc to 6 Volts will allow communication with either high or low voltage units. From the DOS prompt, run the update program UPDATESW. The upload process should complete in approximately 3 minutes. Uploading through the NMEA port: Instructions for uploading software to sensor boards with only access to the NMEA port (i.e. GPS35PC's). Following is a diagram for connecting the first serial port of a GPS25LP based unit to a PC. Refer to the technical specification for your unit to determine which pin or wire is connected to the corresponding signal below. Links to the technical specifications are located at the end of this document. PC 9 pin Female D connector GPS ----. .----- | | 2|------------------------|TXD1 3|------------------------|RXD1 | | 5|----------o-------------|GND | | | ----' | | | | power supply | | ----. | | Gnd|----------' | | | Vcc|------------------------|Vin ----' | `----- From the DOS prompt, run the batch file UPLOAD.BAT with the desired COM port and NMEA baud rate, i.e. UPLOAD COM1 4800. This batch file will run the appropriate executables. The batch file pauses between uploads to allow exiting the batch file in case communication problems are encountered. Press <CTRL> C to exit or any other key to continue. Make certain the uploader program displays ...done before continuing. Technical Specification Links: Pinouts can be found in section 3 of the following documents: http://www.garmin.com/manuals/spec25.pdf http://www.garmin.com/manuals/spec35.pdfDownload Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.