1. CN30WENM_v105.zip Driver
2. Readme.txt File Contents

Readme.txt Driver File Contents (CN30WENM_v105.zip)

v1.05 CN30 Windows Mobile 5.0 Intermec Value Add Web Download (10-05-2005)
--------------------------------------------------------------------------

This Web Download contains Intermec Value Add content to be installed onto CN30 devices if needed.  This bundle is only for use with the v1.44 CN30 Windows Mobile 5.0 load.  Using this content on any other CN30 build is not recommended.


Contents:
---------

_SSTransferAgent.xml    - File needed for automatic install of the CABs.
itcauto.CAB             - Support files used to automatically install the remaining CAB files.
itcivacn30wm.CAB        - DataCollection, scanner/imager support.
magnifier.CAB           - Utility for zooming into parts of the screen for easier viewing.
PrinterSupport.CAB      - CAB file that adds printer support to the device.
SetupASTStart.itc       - File used to properly configure the initial startup.
SuppRCMagneto.CAB       - The Supplicant Funk CAB file for 80211 Security.
WLEnabler.CN30.ARM.cab  - v3.50-09 Wavelink Avalanche Enabler.



Installation Instructions:
--------------------------

1.) Copy the files from the zip file onto an SD card.  Make sure the files are in the root of the SD card.

2.) Insert the SD card into the Device.

3.) Clean Boot the device.  See below for Clean Boot instructions.


NOTE: Make sure the files are not marked as read-only.  Having any of the content marked as Read-only can lead to unpredictable results.



To perform a Clean Boot:
------------------------
1.)  Remove the battery and power from the terminal.
2.)  Cold boot the unit by pressing the button in keypad connector compartment.  The button is on the bottom of the CN30 display module.
3.)  Before applying power, hold down the IO button.
4.)  Apply power to the terminal.
5.)  Continue to hold the IO button for 3 seconds.
6.)  Release the IO button.  The terminal should perform a Clean Boot.