1. 1112291442.zip Driver
2. ReadMe-USB_disc.txt File Contents

ReadMe-USB_disc.txt Driver File Contents (1112291442.zip)

Dear uPSD / DK3400 User,

Thank you for purchasing ST's latest uPSD 8-bit development kit for the uPSD34xx microcontroller.

This directory contains the run-time object file (project.obj) for the USB_disc demo.  Using PSDsoft Express with an RLINK-ST (USB to JTAG dongle), the run-time image can be programmed into the uPSD34xx device on the DK3400.  To do so, follow the instructions below:

1.  Install the latest version of PSDsoft Express with support for the RLINK-ST dongle if it is not already installed.
2.  Launch PSDsoft express.
3.  Click cancel when asked to start a new or open an existing project.  If a project is already open, close it.
4.  Click on the JTAG ISP box in the Design Flow window to open up the JTAG-ISP Operations window.
5.  In the box labeled Step 1, use the Browse button to select the OBJ file to be programmed into the uPSD34xx.
6.  Click on the HW Setup button at the bottom of the window to view the Hardware Settings.
7.  Select RLink in the Hardware Selection window if it is not already selected.
8.  Click OK.
9.  In the box labeled Step 2, click on the Execute button.
10. If the device is not blank, a message will pop up saying that the device is not blank.  Click on Yes to do a full chip erase operation.
11. Various messages will appear in the log window as the device is programmed and verified.  The final message will indicate that the program/verify operation is complete.
12. The application code is now programmed into the device and the uPSD34xx is executing the code.  When the DK3400 is plugged into an upstream USB port, it will function as a USB flash disc device.


Thanks,
uPSD Apps Team.