1. 8038D3A-1.zip Driver
2. PATHWORK.TXT File Contents

PATHWORK.TXT Driver File Contents (8038D3A-1.zip)

   ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿
   ³                  Installation for PATHWORKS for DOS                    ³
   ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ

   A. Software Requirements:

         o MS-DOS 5.0 or later with PATHWORKS for DOS Version 4.1.


   B. Installation with PATHWORKS for DOS Version 4.1

      NOTE: The Pathworks scheduler (SCHK) must be started with the
      switch /N. If /N is not used, initialization may fail with the
      following message:

      "No NIS Interrupt Activity.  Maybe NI_IRQ set wrong or cable not
      attached or hardware/DLL broken"

      a. Automatic Installation for DOS Pathworks Using the Netsetup
         Utility:

         If you install PATHWORKS for the first time or update it using
         installation program NETSETUP respond to the following prompts
         as shown

         a) Select your desired choices for

              Type of configuration
              Destination Drive (boot device)
              LK250 Keyboard setup information.

         b) Select <Ethernet> network adapter type.

         c) Select <Other NDIS> Ethernet adapter.

         d) For full DRIVE:\PATH\FILENAME for NDIS driver, enter

               A:\NDIS2\DC21X4.DOS

         e) For full DRIVE:\PATH\ for the PROTOCOL.INI stub, enter

               A:\NDIS2

            The files are copied from this installation kit to its
            directory.

         NOTE: If PATHWORKS is updated using the NETSETUP installation
            program, it is suggested to copy your old copy of the
            CONFIG.SYS and PROTOCOL.INI files before starting NETSETUP

      b. Manual installation for DOS Pathworks

         a) Copy the DC21X4.DOS file from this installation kit
            to the PATHWORKS directory.  For example:

            C:\DECNET> copy A:\NDIS2\DC21X4.DOS

         b) Add the following line to your CONFIG.SYS to load the
            driver:

            DEVICE=<drive>:\DECNET\DC21X4.DOS


         c) Modify your PROTOCOL.INI file using any DOS Editor by
            appending the PROTOCOL.INI stub (included with this kit) to
            the end of your old PROTOCOL.INI file.  The stub contains
            the following information:

                  [DC21X4.DOS]
                  DRIVERNAME=DC21X4$

         d) Modify the DATALINK and IPX4MAC sections of your
            PROTOCOL.INI file.

            Change the value of the BINDINGS keyword

               from  BINDINGS = driverlabel
               to    BINDINGS = DC21X4.DOS

How To Update Drivers Manually

After your driver has been downloaded, follow these simple steps to install it.

• Expand the archive file (if the download file is in zip or rar format).

• If the expanded file has an .exe extension, double click it and follow the installation instructions.

• Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.

• Find the device and model you want to update in the device list.

• Double-click on it to open the Properties dialog box.

• From the Properties dialog box, select the Driver tab.

• Click the Update Driver button, then follow the instructions.

Very important: You must reboot your system to ensure that any driver updates have taken effect.

For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.