Dear customer,
This modem supports both Plug & Play mode and Non Plug & Play mode.
The mode configuration is set by jumper settings. User should set the modem
into PnP mode when using in Windows 95. In the other hand, user should set
the modem into non PnP mode when using in Non-Windows 95 operating system.
(A) Windows 95 Modem Driver File
The Win95drv.inf file is a driver file for Windows 95. This file is used
for modem installation in Windows 95. In Windows 95, the PnP modem will be
found automatically. Then Windows 95 will query you for the driver used by this
modem. Insert your driver diskette and select the suitable modem type.
If you set the modems into NoN Plug & Play mode, do the following steps:
(1) Make sure the commport of the modem does not conflict with
other hardware in your PC system.
(2) Boot up the Windows 95 and click the Modem icon inside the
Control Panel to install your modem.
(3) Click "Next" to run the "Add New Hardware Wizard". Then
Windows 95 will look for your new hardware.
(4) After the "detection Progress" finish, Windows 95 will find
your new communication port.
(5) Then click "Finish" bar to continue install the modem.
(6) Click "Next" bar in the "Install New Modem" display to let
Windows 95 to scan your modem type.
(7) Insert the driver diskette and click the "Have Disk" bar to
select the correct modem type.
(8) Now, you can install the bundle software to optimize your
modem features.
********* Select the correct type for your modem card.
(select "SpeedCom" 's model)
********* The best way to do the installation or to fine tune the
commports and modem settings, please refer to your User Guide
of Windows 95.
(B) Windows 95 Serial Wave Driver File
The Cir-Wave.inf file is a Serial Wave driver file for windows 95. If your
Windows 95 has been installed the "Unimodem V" function. Then this file will be
required by Windows 95 after you installed the modem driver Win95drv.inf .
Unimodem V is a special function for Windows 95.For detail informations, Please
contact Microsoft.
(C) Flash Utility
The program Loadv34.exe is a flash utility program. User can use this
program to download the new firmware into the flash ROM in order to upgrade
the modem to meet the future ITU-T 56Kbps modem standard.
For example, if you want to download the new firmware (e.g. M540P1.bin) into
the Flash ROM. You can enter the following command under the DOS prompt.
e.g. A:\loadv34.exe m540p1.bin
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.