1. fix.exe Driver
2. FIXIT.TXT File Contents

FIXIT.TXT Driver File Contents (fix.exe)

			Tecmar Technologies

	This file is necessary to change the configuration of
	WangDat 3130 / 3230 back to the standard configured 
	WangDat 3100 / 3200. During our manufacturing process
	there was an incorrect bit set in the firmware inquiry
	string which makes the 3130 /3230 report as a 3130 or 
	3230. In order to keep compatability with the current 
	Operating Systems and third party backup software the
	inquiry string must report as a WangDat 3100 /3200. The
	FIXIT.EXE file has the ability to correct this problem
	and allow the drive to be recognised correctly. Please 
	see below for operating instructions.

	Operating instructions

	First you must have the tape drive attached to the SCSI
	Bus. It must be at the present time be reporting as a Wangdat 
	3130 or 3230. If it is reporting as a 3100 or 3200 there is 
	no need to use this to re-configure the drive. If the drive 
	is not recognised by the SCSI Bus you will probably have 
	the drive setup incorrectly and will need to check your 
	SCSI ID and SCSI termination.

	Once the tape drive is attached and is recognised as a 
	WangDAT 3130 /3230 you must have an ASPI driver for the DOS
	environment loaded in your Config.sys file. You may need to 
	contact your Host Adapter manufacturer for that file. This 
	example below shows the addition to the config.sys file if you
	were using an Adaptec 1540 controller

	Device=c:\wangdat\aspi4dos.sys /d 

	In the above example the aspi4dos.sys file was placed in the 
	wangdat directory. 

	You must now copy the FIXIT4.EXE file to your local hard disk
	or Floppy disk and then type the following as shown below;

	C:>fixit4

	This program will then run and search the SCSI Bus for the 
	Wangdat 3130 / 3230. It will prompt you to select 1 for 3130
	or 2 for 3230 and will then reconfigure it to a WangDat 3100 / 
	3200. You must reboot your system before using the tape drive.