Broadcom Corporation 16215 Alton Parkway, Irvine, CA 92619-7013 Release Note for BCM5700 Engineering Diagnostics for EFI. 10/26/2001 ======================================================== v1.0.3 : 1. Command upgfrm is changed to update vendor ID/device ID of both ROM headers when PXE is upgraded. 2. Enhanced to allow users to config Max PCI retry via secfg. 3. Added BCM5702 and BCM5703 support. v1.0.2 : 1. Fixed a problem where NIC cards can not be detected if it resides on PCI bus number which greater than 16. 2. Fixed a problem where DIAG locks up if firmware doesn't run which enables memory arbitor. v1.0.1 : Fixed serial EEPROM programming issue. v1.0.0 : Initial release.Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.