1. EZ2000p.zip Driver
2. README.TXT File Contents

README.TXT Driver File Contents (EZ2000p.zip)

                                                             Nov 1995
      EZ2000+ Series Ethernet Card Setup/Diagnostic program
     =======================================================

The EZ2000.EXE program (Setup/Diagnostic) lets you configure the EZ2000+
hardware settings, and test the state and cable connection of the card.

To run the program, insert the EZ2000+ driver program diskette in drive
'A' and do the following:

        > cd \UTILITY        --change directory to UTILITY
        > EZ2000             --run the EZ2000.EXE program

        or

        > cd \UTILITY        --change directory to UTILITY
        > EZ2000 /F          --run the EZ2000.EXE with parameter /F
                               if the data in your EEPROM has been corrupted
                               or you cannot configure your card through
                               normal procedure.

        or

        > cd \UTILITY        --change directory to UTILITY
        > EZ2000 /D          --run the EZ2000 with parameter /D
                               this parameter lets you Setup the EZ2000+ by
                               reading EZ2000.DAT file. This way, you can
                               quickly configure your card without going
                               through the menus.

Menu Options
============

1.  EZ2000 lets you configure the hardware settings of EZ2000+.
    You have the option to view/change :

                   . Connector Type
                   . I/O Base Address
                   . Interrupt Number
                   . Remote Boot

2. EZ2000/F lets you configure your card if the data in your EEPROM
   has been corrupted or your cannot configure your card through
   normal procedure.

                   . Node ID
                   . Card Type
                   . I/O Base Address
                   . Interrupt Number
                   . Connector Type
                   . Remote Boot

3. EZ2000/D  lets you configure the card in non-interactive mode by using
   the /D switch.  The EZ2000+ program will automatically read the text file
   EZ2000.DAT located in the same directory.  The following is an example:

                   . Connector Type       UTP
                   . I/O Base Address     0x300
                   . Interrupt Number     5
                   . ROM Size             16k
                   . ROM Address          0xD0000

 Note:
   1. Setup will only change the setting that appears in EZ2000.DAT, and other
      setting will not be changed.
   2. If any setting about boot ROM (ROM Size or ROM Address) appeared,
      boot ROM will be set to 'Enable'. Otherwise it will set to 'Disable'.
   3. If connector type is not configured, the driver will automatically
      detect the active media connector.

4. DIAGNOSTIC lets you diagnose the state and cable connections of EZ2000+.

How To Update Drivers Manually

After your driver has been downloaded, follow these simple steps to install it.

• Expand the archive file (if the download file is in zip or rar format).

• If the expanded file has an .exe extension, double click it and follow the installation instructions.

• Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.

• Find the device and model you want to update in the device list.

• Double-click on it to open the Properties dialog box.

• From the Properties dialog box, select the Driver tab.

• Click the Update Driver button, then follow the instructions.

Very important: You must reboot your system to ensure that any driver updates have taken effect.

For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.