1. 3c575bt.zip Driver
2. PROTOCOL.INI File Contents

PROTOCOL.INI Driver File Contents (3c575bt.zip)

    DriverName = "ELPC575$"
;
; below are examples and explanations of some of the keywords supported by
; the 3C575 NDIS 2.01 driver.  most of the lines are simply comments.  the 
; marked with "-->" are lines that can be edited (removing the ";-->" and
; lines replacing it with spaces, and modifying the right hand side as
; appropriate.
;
; IOADDRESS = 0xF000
;       adapter base address (optional)
;       If parameter not present in protocol.ini, driver uses the value
;       saved from running Diagnostic/Configuration program.
;       This parameter is only used to specify a single adapter in a multi-
;       adapter configuration. Must match value set by Diagnostic/Config.
;       Use 0x400 - 0xFF00 in steps of 0x100
; INTERRUPT = 0xA
;       interrupt channel number (optional)
;       Use 3,5,7,9,0xA,0xB,0xC,0xF  
;
; MAXTRANSMITS=n, n=6..50, specifies the number of transmits which can be 
; queued up by the driver when the TxFIFO is full or the adapter is otherwise
; busy.  When we run out of queue entries, an OUT_OF_RESOURCES error will be 
; returned to the protocol on a transmit attempt.  Most protocols will handle
; running out of resources will little performance degradation.  However, 
; some implementations will drop packets and consequently lower performance 
; if OUT_OF_RESOURCES is returned too often.  The default value is 6, which 
; should be sufficient for most cases, and is adequate for window sizes up to 
; about 6 or so.  On a heavily loaded server with a lot of active connections, 
; you may want to increase this number since with large windows on multiple 
; active connections you may need a bigger transmit queue to handle them all.
; Each queue entry takes about 128 bytes of memory, so increasing this number
; will increase the resident size of the driver.
;
;-->MAXTRANSMITS=40
;
; NETADDRESS allows the user to configure the network address of the adapter,
; rather than using the one in EEProm.  If not specified the address on the
; adapter will be used.  If specified, the right hand side must be exactly
; 12 hex ASCII characters which will be converted to the network address.
; The only restrictions we impose is that the address not have the multicast
; bit set (an odd number in the second digit) and the network address have
; bit one of the most significant byte of the address set.  This bit 
; signifies a locally administered address.
;
;-->NETADDRESS="006097123456"
;