1. level_one.zip Driver
2. NWODIDOS.TXT File Contents

NWODIDOS.TXT Driver File Contents (level_one.zip)

   Workstation for DOS ODI Client

   Introduction:
   -------------
   This document describes the procedure to setup the NetWare v3.X, v4.X,
   5.0 workstation driver for LevelOne 10/100Mbps Fast Ethernet Adapter.

   Location of Driver:     \nwclient\FNC107.COM

   Sample Configuration Files:
   ---------------------------
     STARTNET.BAT:
         LSL
         FNC107
         IPXODI
         NETX or VLM (VLM's for NetWare 4.x, 5.0)

     NET.CFG:
         LINK DRIVER FNC107

           MEDIUM MM  --where MM is one of AUTO, 10HALF, 10FULL, 100HALF,
                        and 100FULL, to specifiy the media type.

           BUSNO NN   --where NN is the PCI bus identifier of the PCI bus
                        which connects to the adapter.

           DEVICENO NN --where NN is the specific PCI BIOS device
                         identification number of the specified PCI adapter.

          [ or you can use "EtherID" to select a specific FNC107 adapter:
           EtherID 006067NNNNNN --Where 006067NNNNNN specify a FNC107
                                  adapter's node address. This is only
                                  required when more than one FNC107
                                  adapters exist on one system.
          ]


           FRAME Ethernet_802.2 --Specify frame type
           FRAME Ethernet_802.3
           FRAME Ethernet_SNAP
           FRAME Ethernet_II

         NetWare DOS Requester
           FIRST NETWORK DRIVE = F
           NETWARE PROTOCOL = NDS BIND
           PREFERRED SERVER = NW411


   Setup Procedures for NetWare 3.12 Client :
   -----------------------------------------------
      Before you start with the installation process, make sure that
      the  adapter is properly installed and configured. Make sure
      that your NetWare workstation is properly installed.

      1. Copy FNC107.COM from the FNC107 Driver Diskette subdirectory
         A:\NWCLIENT to your harddisk.

      2. Update STARTNET.BAT batch file as sample above

      3. Edit the NET.CFG file that you copied over. Edit the file per your
         requirements (see examples above). If there are two frame types
         listed, whichever frame type is listed first, that is the one that
         the  driver will load. See above for examples. The NET.CFG file
         should be in the same directory with the LSL.COM file.


   Setup Procedures for NetWare 4.X, 5.0 Client with vlm:
   -------------------------------------------------------
      1. Make a new directory NWCLIENT(or other name) on C drive

      2. Copy A:\NWCLIENT\*.* to C:\NWCLIENT\*.*

      3. Create STARTNET.BAT batch file as sample above

      4. Add a line "@CALL C:\NWCLIENT\STARTNET.BAT"(ingore symbol "")
         on the first line of AUTOEXEC.BAT file.
         

   NOTE:
   -----
      1. Be sure LASTDRIVE=Z in your CONFIG.SYS file for the
         network mappings to work properly.

      2. When you have multiple FNC107 Adapters on your system:
         Use "BUSNO" and "DEVICENO" KEYWORD in NET.CFG to select which
         adapter to use with your netware client.(or you can use "EtherID")


                                                        -- End --