1. ob2000.zip Driver
2. README.TXT File Contents

README.TXT Driver File Contents (ob2000.zip)

INSTALLING WINDOWS SOUND DRIVERS
================================


REQUIREMENTS

     * HP OmniBook 2000/5700 installed with Windows 3.1 or Windows for
       Workgroups 

     * HP OmniBook 2000/5700 Sound drivers.  The drivers are located on the
       OmniBook hard disk in C:\OMNIBOOK\DRIVERS\WFW\SOUND\DISK1 and DISK2 
       directories.  These files are available after finishing the selection
       of Windows 95 or Windows for Workgroups during the pre-install process.
       The files are also located on the HP OmniBook Recovery CD in the 
       \DRIVERS\WFW\SOUND\DISK1 and DISK2 directories.

Note ** The Windows Sound drivers must be installed from floppy disks.  Copy
        the contents of DISK1 and DISK2 to floppy disks.


PROCEDURE

1. Start Windows

2. Insert the HP OmniBook 2000/5700 Sound Drivers Disk #1 into the A: drive

3. Choose the File menu then Run

4. Enter A:\SETUP and press <ENTER>.

5. Follow the instructions displayed. (choose the defaults). 

6. You will be prompted to insert DISK2.

7. Exit Windows and Reboot.  When Windows starts, you should hear the default
   Windows sound and a Crystal Semiconductor wave file.


NOTE: Make sure the following lines are included in your AUTOEXEC.BAT and 
      CONFIG.SYS 


      CONFIG.SYS
      ----------
      DEVICE=C:\CRYSTAL\CS4232C.EXE

      AUTOEXEC.BAT
      ------------
      C:\CRYSTAL\CS32MIX /C=13 /L=13
      SET BLASTER = 220 I5 D1 T4